Recent content by d4nvu

Haha thanks, I am in America. I am just looking for the other option where I can keep the fuse as well. Has the solution from O'Reilly's been reliable for you?

Bump on where I can source this diode to maintain the 7.5A fuse

IIRC spacers that are 1.25" and under need to be notched to fit the front hub. Anything above 1.5" (or is it 2"?) will clear fine and do no need to be notched. Source: I have a set of SpiderTrax spacers 1.25" that are notched, I have tried a similar set from Amazon that are not notched and...

PM'd

Hi All, looking for 1.25" spacers specifically for the 100 series. Hubcentric only please. Thank you!

The wavian should work fine. I am using scepter here.

Sorry, should've clarified. I meant could the wings open up with the seats up, but looks like the REEF is designed to do so, while the KISS needs to be notched

https://www.facebook.com/Valley-Hybrids-216957024981396/

I wedged a screwdriver in and pried. I then turned it and kept prying on each side until it broke loose. I would put a nut on the end of the stud so your fan doesn't come flying off into the radiator. Sometimes the clutch fan can be extremely stubborn since it's been on for the the past 180k...

That's awesome and a great idea! I have some spare yakima racks laying around that I can probably use. I want to run mine on the swing arm as well. I was looking at aftermarket options but I'm afraid all the ones on the market would stand really high up.

Anyone running a snowboard/ski carrier via the hitch mounts? Curious what everyone is running

Anyone running this rack with a soft shell tent? So far, Ive only really seen it with hard shell popup/clamshell tents. Looking to switch from Frontrunner (so noisy it's annoying)..

I went with Dissent - Local, high clearance, modular, available aluminum option (I live in SF closer to the fog, so salt air is an issue), and one of the few that ALSO has an attractive matching rear bumper. I only wish the LX version had a bull bar option that was straight like the LC version-...

Awesome progress! I find that using milk crates help when installing sliders solo

I dremeled the rear of the box and it fit without a spacer. If you use the spacer you might get away with not having to dremel. I would double check. You will need longer screws (at least 1") as the OEM screws are too short. I just used some drywall screws that I had on hand. Good luck!