Recent content by cryan

I'm not sure if they've been reworked or if the published dimensions have changed. My luck with predicting actual lift height with Dobinsons coils has been pretty poor. I've posted some of this in other threads but I started with the 59-540 front coils (1.4" with no load advertised) and 59-535...

I have this one which is basically the same as the ultimate MX hauler. This style is the way to go. I had one of the traditional tray style ones and could never get it as secure as I wanted due to the moto suspension being a factor. I've used them both on my sprinter and on my LC200. On the...

I have had the IMS on mine for the last few years and they have been great. My only complaint with Dobinsons is that selecting the right coils for a desired lift height is tricky. I started with the 59-540 front coils (1.4" with no load advertised) and 59-535 rear coils (which was 2" no load at...

Interested. Will send pm

Sent pm. Interested if still available.

Thanks. I’m not particularly fixated on progressive coils. Just need less rear lift to improve rake. This was the same spec sheet I used when ordering but the C59-535 ended up being a lot more than 30mm. The dobinsonusa website now has them at 75mm with stock load and 50mm with 100kg constant...

I have the C59-535 coils installed but gave me more lift than I was planning on. Would like to swap for the c59-559V if anyone is interested. Or purchase if anyone’s pulled any off. Located in Austin, TX.

Both floor areas are dry under the weathertec liners. And passenger was completely dry since no one had been in it for a while. A little ice on top of the cowl but not a ton. And it has been in a carport for most of the winter, so not consistently buried. There have been a few other quirks but...

Boots I think but will inspect further.

Not really. It’s been surviving a snowy winter in CO so there has been some moisture but have all weather floor liners in so don’t it’d be considered excessive

I’m trying to narrow down potential causes. One of the symptoms I’ve noticed is that the hvac blower seems to be staying on after the vehicle is turned off, at least in the defrost zone. Has anyone seen anything similar?

Done. It doesnt even have to be good beer. I'll PM with my contact info.

Bump. Still sitting in garage.

The bastrop presence on here is pretty crazy. I lived there in 2011 during the fire but fortunately was spared. In Austin now.

I think I used the tjm washers (did not reuse originals). I wired the led fogs directly in as they were in stock config and did not use relay with switch. No blown fuses so far. I actually haven’t done anything with the turn signals in the bumper yet but I’m not sure there is a way to get them...