Recent content by coax

Thanks all I think they are now all spoken for. Andy saw your message on RS so will get one in mail to you.

I have a bag of these from replacing mine a long time ago. They are not exact fit but work well enough. Give me an address and I'll send to you. And then pass the others forward. Or if multiple folks want I can send in envelopes. I think 6 left. -Corey

Anyone have any leads on rear lift springs for a new model highlander/kluger? Seems all the major makers like king stopped making them for these vehichles in 2017. Which is unfortunate as even unloaded the rear springs are too soft. Load in a few things and even towing a small trailer at...

Have some extra bits left over after rebuild last year and the machine shop reworked my existing head; Both Camshafts Set of buckets/shims Caps/bolts Valve Cover All of this is used take off from a early model 1fz head that I ended up not using as it the bores were more out of line than my...

Thanks! Lockers are the factory elockers, regeared 4.88 front by robbie and rear by zuk.

Finally decided to sell. Again. For the 3rd time. Each time couldn't bring myself to do it. Just no more time to use/wrench with small kiddo and crazy work. Located in Bend, OR so really just posting here on the off-chance someone has contacts in Bend that may be interested. Craigslist...

No return spring connected from what I can tell. I had same issue where I forgot to put it back on when I reassembled. Almost exactly what happened to me. Replaced brake booster, in some cases it would pull down the pedal and I'd have to use my toe to pull back up. Was totally dismayed after...

Can't speak for OE booster, but the high quality aftermarket(or maybe oem as listed on their page) from Cruiseryard came w/ the check valve. I just bought the two gaskets and installed it. good to go.

After a few years of water draining into my headlights (due to removed wind faring on hood but not knowing I needed to replace the rubber stripping underneath that was removed when it was installed), my headlights were pretty much worthless. Owning an LX450, my options were as follows: Order...

You could always try...if you hae a real mechanic that diagnosed that as the failure and still have the filter (wasn't thrown away) submitting the form may be worth a few min of your time on the off chance it works Lots of us either diagnosed ourselves or didn't have the filter which makes more...

Yup thats what I envisioned the internals looking like. For others that find this thread, some good info here: Parts for steering box rebuild - https://forum.ih8mud.com/threads/parts-for-steering-box-rebuild.1254109/ West Texas offroad was the bees knees a number of years back and why I...

@tway Worn components within the box that could not be adjusted out by preload. My guess is both the sector shaft and power piston teeth gears had worn down too much due to poor maintenance by PO's for the original 180k miles. I have since replaced the whole steering box with new from toyota...

You can bore out +1 on a 1fz-fe with no downsides. You can use aftermarket or Toyota components as you desire. No affect on longevity other than you are rebuilding new so will last longer than the existing components. It does add a bit more pep in my personal experience, partially due to the...