Recent content by claiborne86

  1. claiborne86

    Power steering ISSUES Need some HELP!!

    Yeah, what I’m telling you I thought I was gonna be OK. I really thought I was good. I have a factory service manual and saw the warnings. Silly mistake. The pump turns perfectly smooth. The depth was just a bit over 3/8 of an inch as I paid attention and put some calipers on it before I removed it.
  2. claiborne86

    Power steering ISSUES Need some HELP!!

    I agree with everything you just said. this weekend I’m going to remove the pump again and bore scope the oil pump gear. Then I’m going to start up with the stethoscope and listen to that area for any ticks. I have not seen where people have to remove the head but understand what you’re saying...
  3. claiborne86

    Power steering ISSUES Need some HELP!!

    just posted video thanks again
  4. claiborne86

    Power steering ISSUES Need some HELP!!

    just attached video
  5. claiborne86

    Power steering ISSUES Need some HELP!!

    T Thanks Shipwreck. I used a steel rod to isolate the sound. Have you ever had the front of the engine taken down to that point?
  6. claiborne86

    Power steering ISSUES Need some HELP!!

    You're a saint brother, The sound is almost a rod knock sound. I used the metal rod held to ear to isolate the sound and it was beyond apparent that it was the pump. I am going to try to post a video now.
  7. claiborne86

    Power steering ISSUES Need some HELP!!

    First and foremost thank you for opening this and hopefully you will take a moment and read the list below. I will go ahead and post the question I have here and those of you that read all the way down will read what has caused me to ask this question. The question is .... How many people have...
  8. claiborne86

    Terrible vibration at 20mph under power

    Thanks man, I pulled the driveshaft and found a bad u joint that looked and felt fine until pressed out. Thank you for the responae
  9. claiborne86

    Terrible vibration at 20mph under power

    Hello everyone, I have a 1996 lx450 that has been an ongoing project for the past year. I am going to list what is modified and recent maintenance. These will clear up the usual culprits. Part time kit and Spartan lockers f/r Full f/r axle job Adj panhards Ome 3”heavy Metal tech rear control...
  10. claiborne86

    Jean is down help me out!!!!!

    Yes fuel to the fuel filter. Haven’t checked through... fuel filter was replace 20k ago
  11. claiborne86

    Jean is down help me out!!!!!

    I swapped a good fusible link in And no change. Neutral safety switch makes sense I guess
  12. claiborne86

    Jean is down help me out!!!!!

    Good afternoon everyone I need some help again... so my 94 fzj80 “Jean” died on me a week ago. She was running great and had just done about 1000 miles on some off-road overland type adventures. Pulled up to a stop sign and she stalled not to be re started. She is doing some quite strange things...
  13. claiborne86

    Stalling issues - Will my LC ever be reliable?

    Yeah man don’t give up you will get it. Look on the plus side when you get it you will know every inch of it. That’s what I tel myself haha.
  14. claiborne86

    Stalling issues - Will my LC ever be reliable?

    So I have a 94 and it gave me hell trying to figure out what the intermittent issues were. Mine would run rough cut off stutter like hell and drove me crazy . I spent a fortune chasing wiring issues and fuel and this and that and did 02 sensors. Ended up being the brand new but cheap distributor...
  15. claiborne86

    1994 Fzj80 severe miss Please Help!!!

    That’s the next step. Then the coil and iac thanks again
Back
Top Bottom