Recent content by cgmud

Mine does impact the hood insulation. The hood is raised 1-2mm as a result.

So if I were to swap out PS pumps with a new 1-HDT one from Toyota USA, are these the following components that are "one-time use" and replaced at the same time? Do I need the gasket kit or only if I am rebuilding? O Ring - 96711-19019 Pressure Port Gasket - 44327-30030 O Ring - 90301-60002...

I would find a CT26 and get it refurbed like you’re originally looking for. I have one still. I’ll check to see if it has the crack you’re talking about.

I’ve done it on mine. I had to extend the threading for the wing nut but that was fairly easy. You will also need to do some light trimming of the sharp line at the top of it so you have enough flat circumference to get a clamp around the opening. And it because of the increased height it does...

Another code 257168668224946228 Expires Dec 13

Yup exactly. I trimmed as well. Should have trimmed more but it got inset enough to work well.

I’m not sure if my install was optimal, but I took the included speaker adapter of those Infinity’s and screwed them into the door. Then put the door card on and screwed the speakers through the door card into those adapters. That includes no after market spacers. I installed the same in the...

The pre-95 is absolutely terrible for wire options. I'd be interested to hear creative ways people have gotten wires to this area for those model years.

None. Unlimited sharing unlimited use.

257168668224946228 Good until March 1st

Shouldn't be any different than the US 80s. You have a number of options. Delta, Slee, Trail Tailor to name a few.

Turbo still available!

Cruisin is available again thanks to @TRAIL TAILOR https://www.trail-tailor.com/store/p191/80_Series_Cruisin_Skid_Plates.html

https://cars245.com/en/item/depo-2121173PXLDE-headlight/ Does this help? This is where I grabbed my LHD DEPOs for my RHD 80.

Selling AISIN 1HDT/1HZ Diesel Hub Fan Clutch out of my 1-HDT. $100 + shipping