I constantly use the cruise control. Taking the daughter to school the other day, I noticed the pull back on the cc switch had a lot more give in it than normal. After a couple minutes of fiddling with it while driving, it completely snapped off and was left dangling. Luckily, the replacement is...
Yeah, something was up with the compressor. It ate the rebuild clutch I put in a couple months after the work. And produced the same sound again. I ultimately replaced the compressor and condenser. No issues since then.
https://forum.ih8mud.com/threads/a-c-condenser-replacement.1316283/
Good timing on this bump. I just put in my first order on Tosshin for a couple small items and it's been stuck in "stock verification" ever since. Has anyone else had the stock verification process take a while too?
Yes, the stock bulb is halogen. I swapped out the dead on arrival halogens for LEDs soon after we bought the rig. Always had problems with the LEDs, as they would flicker. Then the driver side went out completely. I bought some new LEDs off amazon that had good reviews for being able to dim...
Driver side running board light has been out for a while. Decided to pop a new bulb in there and noticed the new led fainting comes on, flickers and then shuts off. Tried with a halogen and the bulb gets a little warm. Tried passenger side with both bulbs and no issues.
Multi meter showed that...
Hey guys, got some coolant leaks on the pipe from the thermostat all the way back to the firewall. PAIR system has been removed on my '94, so I'm looking to move to the 1 piece solid pipe from the 95+ which I know is now NLA. I know there are a couple other items that are probably NLA so it will...
@FrazzledHunter
That part is a bit different with the Andersen. It's best to detach and attach at the same angle if possible. It's not super horrible if you don't. With the AHC, pop it into high mode and jack up the back even more until there is enough slack in the chains to get them...
Using an Andersen here. Nothing but praise for it. Our family moved last year from Oregon to Arizona and I pulled a 24 foot car hauler trailer down there twice(1300 miles one way, 5200 miles total).
First time, with my '90 300zx TT tucked inside with a bunch of other household items. I...
I've replaced the pistons with aftermarket in plenty of calipers on Nissan and Toyota rigs. Never had any issue. I have only used replacement seals from the same company though. I say, rock it.
Got the LX blowing cold again after sticking in a new compressor and condenser. I detailed some notes on the process below. No more weird sound coming from the compressor when the clutch is engaged anymore.
https://forum.ih8mud.com/threads/a-c-condenser-replacement.1316283/#post-15043035
Finally got around to getting this job done. Took my time on it since it's blistering hot down here in AZ. Currently on track to beat a record of 18 consecutive days above 110. I would usually go out to work in the garage in the mornings and call it quits when the garage temps reached over 100...
AC took a dump about a week ago after a failed compressor clutch rebuild. Compressor is eating clutches so I ordered a new Denso compressor and condenser(which includes the drier). Compressor seems pretty straight forward but haven't been able to find any threads detailing a condenser...
UPDATE: Well, along with the aforementioned pulley swap, I had been having a Jetson's/Chitty Chitty Bang Bang sound that would come and go with the compressor cycling. It never really went away after I swapped on the new clutch. I figured the compressor would probably fail at some point but...