Recent content by 76classic

New clutch master cylinder

No. They cleaned them up a bit but did not restore, refinish or polish. They were in pretty good shape other than the webbing. They may offer that service. You would have to ask. They are very nice people and run a clean operation from what I can tell.

https://www.safetyrestore.com/massachusetts/westfield-seat-belt-repair I dropped them off and picked them up 24 hours later. I know you can mail them in and they will send them back. They go through the mechanisms and clean them up. Very satisfied. For my truck it was $100 per belt front 3 point...

Got the seat belts re webbed. Finally. One of that last things I’ve been putting off.

Daily driver completed last winter.

Yup. I’m seeing emissions parts in there. Make sure you don’t trash them. Getting very hard to come by.

I used one fel-pro. I had intake indexed before install and it was close, not perfect. Torque again after a certain amount of time per instructions. Works perfect.

I’ve got a 1976 with stock aisin set up. Happy to help if you post a pic.

I’m gonna say no. I’ve got the setup your talking about. Did a 2.5” shackle lift from ccot.

Thanks for that. I’ll give it a try.

I’ll go over all those during fresh tune. Front end is spot on. Getting a bit of unburnt fuel smell between shifts. I’ll look up what “dizzy recurved” even means.

Thank you. I’ll give it a try.

I figure about 10% also. 50 mph on the odometer is actually 55 mph on my GPS. So even at that ratio, I’m getting between 9 and 10 mpg. Sounds like we have very similar set ups, except I have bone stock carb and dizzy. Plus no engine work ever on mine. I’ll throw a fresh tune on it and check it...

I get about the same per tank. I’ve seen other posts where people are getting 12-14 mpg on stick rigs which has me wondering if there may be something wrong with my set up.