Recent content by 4wheelforay

Micah, was your truck going into "limp home" mode when it was throwing that code? I recently purchased a 98 LC, and on the coldest day of the year it started, shut off, started again with a little throttle input, and drove fine. Upon restart after reading the code at autozone it went into limp...

I have some serious rust issues with my 98LC liftgate, I purchased a 2001 (I believe '01, could be '02) as a replacement but it appears that the wiring harness is vastly different. I was under the impression that they were a simple swap, same size, same internals. The 98 has 10 pin (8 used) and...

Looking for a glass headlight for the drivers side (left)

Do you have the lift gate and drivers side rear door?

In many cases fuel lines are designed to collapse in the event of a fire. I believe that excess heat is the root cause for some of the problems here. I found this searching if I needed to replace my rusted cat heat shields.

U joints were my problem. No noise, no vibration after replacement. I think I spent $32 on parts and $40 at a shop to press them out. It took maybe 30 minutes total to drop it and reinstall, you could probably do it faster if you weren't concerned with dropping a driveshaft on your face. I...

I think this thread has a few people with different problems. i.e. u joints, harmonic damper, unbalanced tires, bad wheel bearings. But I'm a newb.

Mine was not on the truck at the time of purchase. I don't have a drone, it is a terrible vibration. I would be interested in putting the damper back on though, need to find one.

:bang: Thank you... Safe to take to highway speed with it locked?

I just pulled my rear driveshaft after getting a terrible vibration at 70+mph. I had the rear tires balanced and the vibration was reduced but didn't go away. I then had the front tires balanced but there was no difference. I thought I might have messed up the wheel bearing install I just did...

PM Sent

This is on my to-do list. Significantly less overwhelming than the dealer made it sound. Best place for parts? The dealer that gave me the estimate of $700 to do this?

I don't really care for that stuff, I think it seals the rust in... I know nothing of it though. I am going to hit the frame and doors of the truck with Fluid Film before we get salted roads.

Thanks, I used the "rust to black" filter on my phone.

Hello all, Although I haven't used the site often, you guys do a great job. I knew I wanted a 100 to replace my aging Buick Century. I was thinking I was going to have to wait until spring but one came up on craigslist yesterday for what I thought to be a good price ($3900.) It is a '98 black...