Recent content by 1863

Is there an adjustable rear upper control arm that uses stock bushings? I'm fighting some vibrations and want to adjust the pinion angle on the rear. (extended lowers????? There seem to be a lot of options for these vehicles for any modification) Running standard OME heavy lift with...

The crate engines seem to have standardized parts. It uses the ls3 MAF sensor and the instructions say to use 4”. I’m gonna try temporarily removing all 90 angles to see if it’s a turbulence issue.

Modified truck pan from Mark’s

Thank you. The intake is supposed to be 4”, which is what I have.

Need some help getting MAF to work. Setup: L96 crate engine with GM performance harness. (not relevant but 6L80 with tap shift ;) using 4: aluminum tube with MAF 10" from throttle body. The harness instructions state the MAF must be 10" from the throttle body and at least 3" from upstream...

$300

Working VAF (not maf) from running 1994 land cruiser. Pulled engine for LS swap.

Same here. Not sure what to do.

Awesome. Got the email with the instructions. Couldn’t be happier with the product and the customer service during this group buy.

Received my drawer system. So far it looks great. This may be a stupid question, but do I leave the carpet in or take the carpet out?

Yup. Still available.

Kernal, Thank you for the clarification.

Thank you. Do you know the difference between the two? Year?

Thank you for the reply, but that doesn't clear up my confusion. Both numbers have 47730 (RH)/47750 (LH) as the beginning. Is the correct ending 60060 or 60061. That is the confusion.

1994 with ABS and ff rear. Trying to figure out which OEM calipers I need. I searched the forum and just got more confused. Hoping someone who 'knows' can answer definitively. I tried ordering 47730-60061 and 47750-60061, but was informed that these do not fit my vehicle. They are...