- Thread starter
- #21
Started cutting on the driver side .. worse ? Better ? Not sure ... pretty similar in the end ...
Metalwork is enough on the passenger side for what I intend to do with that truck . Should be plenty solid and nice to see from 30ft - 30mph .
Driver side look like that :
Inner fender is cleaner around the wheel well but need more attention in the rear section .. the quarter panel lower section is also gone but I already knew that so I mirrored the parts I made on the passenger side and its already almost covered. Here is my worst concern :
The other side wasnt that bad ... so I will have to figure out what to do there . Found a few inspiring builds with that section rusted too that were fixed nicely so , again , more to come
Metalwork is enough on the passenger side for what I intend to do with that truck . Should be plenty solid and nice to see from 30ft - 30mph .
Driver side look like that :
Inner fender is cleaner around the wheel well but need more attention in the rear section .. the quarter panel lower section is also gone but I already knew that so I mirrored the parts I made on the passenger side and its already almost covered. Here is my worst concern :
The other side wasnt that bad ... so I will have to figure out what to do there . Found a few inspiring builds with that section rusted too that were fixed nicely so , again , more to come