1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Looking for Unique FJ40 Door Part

Discussion in '40- & 55-Series Tech' started by 1973Guppie, May 5, 2003.

  1. 1973Guppie

    1973Guppie

    Messages:
    8,739
    Media:
    31
    Likes Received:
    619
    Joined:
    Jan 31, 2003
    Location:
    "the whale's vagina", CA
    I am looking for a specific door piece. This is the piece that fits on the inside curve of the hard door and holds the catch assembly to stop the stock door from swinging into the fender. It looks like 2 small washers on top of one another. This piece was somehow ripped right off the door by a previous owner. I was hoping someone out there has a junk hard door that they could cut this piece out and ship to me? I would like someone to cut it out along with the curve in the door so I can reweld it on my door and overlap the metals. If anyone can help please email me at the address below. Thanks!

    Noah
    noastoy@san.rr.com

    Guppie
    1973 FJ40
    San Diego, CA
    99 V8 Vortec/SAG PS/33'BFG MT/No Tranny/Stock TC/ARB's F+R/Onboard Air/ON Blocks/Rear Storage/Soon to be Beige with Black Trim!
    http://www.imagestation.com/members/1973Guppie
     
  2. Degnol

    Degnol

    Messages:
    8,123
    Media:
    16
    Likes Received:
    6
    Joined:
    Jan 22, 2003
    Location:
    Kansastitty
    You can just make one out of some flat stock, like 3/16 x 1/2" :). Bend it into a "U" shape and drill a hole for a clevis pin then weld it on.