G'day everyone Julian from Australia. I had a wheel alignment done today on my 75 and I had +0°45' on the left hand front. So the guy tells me it's a little out of wack and I can put camber king pins bearings that's are offset. Now I'm due to do my swivel hubs as one is starting to seep and when I did it last time I just reused the shims which makes me think I shimmed it wrong. Could it be possible that wrong shims can cause camber and also looking at workshop manual it only says put shims on the top and my ute has shims on top and bottom. Could someone shed some light as I want to re do my hubs and I want it right.