60 Series Bullbar Schematic (1 Viewer)

[Stickboy]

I'm looking to build a bullbar for my 60. I'd like to stick with something similar to the ARB commercial bullbar without a winch.

Instead of re-inventing the wheel I'm wondering if anyone who has built their own bullbar has a schematic/engineering diagram of it. I have resources to bend most metals so anything should be a go.

My intent is to create a bar that'll protect the front of the rig from animal collisions since I'm planning on doing remote travel on fairly decent gravel roads. I've hit deer in the past and had everything come to an end at that point.

thanks,
mike

 

[ginericLC]

i don't have dimensions and I sold the rig. This is what I came up with. It was much higher profile than an ARB. 2x4 rectangular tubing lower supports, 1/4" uprights, 2" tubes, 5/16" winch plate.

 

[Stickboy]

that's what i'm looking for...
any other pics of it, side, while building, details etc....
where did you get the tubing bent?
where in ID are you, I'm in Moscow....
thanks,
mike