Has anyone had an issue with the AHC fusible link (Part No.: 90982-08285) failing? About 8 months ago, my AHC system dropped to low and the "OFF" light started flashing. I inspected the fusible link and it failed. I ordered a new one, replaced it, and all was good until a few days ago when...
Can anyone confirm that the total height of the Prinsu rack installed on a LC base with stock tires and suspension is < 78"? Of all the rack options, the Prinsu seems to be the lowest profile and I need to stay under 78" in total height for parking garage purposes.
This is very helpful and I appreciate the link. Have you installed the new master switch yet and did it solve the problem? I assume swapping it out is pretty simple task... easier than door lock actuators...?
Looking for some guidance. I have a 2005 LX470. Some of the windows stopped working, here is the summary:
DS Front - Works normally
PS Front - Only works from the window switch on the PS door
DS Rear - Does not work from driver's switch or the door switch
PS Rear - Only works from the window...
I replaced my rear brake pads and rotors a few months ago and had the same problem. It was admittedly the first time had done this and the video linked in this thread was really helpful. The grinding issue I caused was due to the parking brake shoes being out of alignment. When I pulled the...
So I tackled the job of replacing the rear rotors and brake pads over the weekend. I did the driver's side first and it took about two hours, mainly due to the fact I was figuring it out as I went along and I screwed up removing the rotor... more on that in a minute. The passengers side took...
A huge thanks to all. This is a treasure trove of information and I appreciate all of the guidance.
One follow up question now that I'm looking at parts again. It appears there are four different Plate Pad Supports:
47716-22060 Pad Support #1
47717-22050 Pad Support #2
47718-22040 Pad...
A few questions... I am planning on replacing the rear rotors and install new brakes pads. I've replaced brake pads before on the front but I've never replaced rotors. I've watched this video:
How long should the 8mm bolts be that are used to remove the rotor? Is it necessary to...
Replaced the Heater Tees using the informative post in the FAQ section. I had noticed a coolant leak... when I removed the tee on the "hot" side it simply broke apart. I probably should have replaced them before the 181,000 mile mark. Next up... front sway bar bushings.
Anyone had a front wheel bearing fail 9000 miles after having them repacked? I took my truck in to have the front brake pads replaced, rotors turned, and wheel bearing re-greased back in the spring. I started noticing poor breaking performance this weekend and noise coming from the DS front...
Thanks to you both. I have a Blue Sea 6 circuit panel waiting to be installed and had thought about picking up a negative buss bar to simplify routing a ground wire to the trailer frame. I've got one of the NoCo power inlets so I can plug an extension cord into the charger without having to...