Has anyone had an issue with the AHC fusible link (Part No.: 90982-08285) failing? About 8 months ago, my AHC system dropped to low and the "OFF" light started flashing. I inspected the fusible link and it failed. I ordered a new one, replaced it, and all was good until a few days ago when...
Can anyone confirm that the total height of the Prinsu rack installed on a LC base with stock tires and suspension is < 78"? Of all the rack options, the Prinsu seems to be the lowest profile and I need to stay under 78" in total height for parking garage purposes.
This is very helpful and I appreciate the link. Have you installed the new master switch yet and did it solve the problem? I assume swapping it out is pretty simple task... easier than door lock actuators...?
Looking for some guidance. I have a 2005 LX470. Some of the windows stopped working, here is the summary:
DS Front - Works normally
PS Front - Only works from the window switch on the PS door
DS Rear - Does not work from driver's switch or the door switch
PS Rear - Only works from the window...
I replaced my rear brake pads and rotors a few months ago and had the same problem. It was admittedly the first time had done this and the video linked in this thread was really helpful. The grinding issue I caused was due to the parking brake shoes being out of alignment. When I pulled the...
So I tackled the job of replacing the rear rotors and brake pads over the weekend. I did the driver's side first and it took about two hours, mainly due to the fact I was figuring it out as I went along and I screwed up removing the rotor... more on that in a minute. The passengers side took...
A huge thanks to all. This is a treasure trove of information and I appreciate all of the guidance.
One follow up question now that I'm looking at parts again. It appears there are four different Plate Pad Supports:
47716-22060 Pad Support #1
47717-22050 Pad Support #2
47718-22040 Pad...
A few questions... I am planning on replacing the rear rotors and install new brakes pads. I've replaced brake pads before on the front but I've never replaced rotors. I've watched this video:
How long should the 8mm bolts be that are used to remove the rotor? Is it necessary to...
Replaced the Heater Tees using the informative post in the FAQ section. I had noticed a coolant leak... when I removed the tee on the "hot" side it simply broke apart. I probably should have replaced them before the 181,000 mile mark. Next up... front sway bar bushings.
Anyone had a front wheel bearing fail 9000 miles after having them repacked? I took my truck in to have the front brake pads replaced, rotors turned, and wheel bearing re-greased back in the spring. I started noticing poor breaking performance this weekend and noise coming from the DS front...
Thanks to you both. I have a Blue Sea 6 circuit panel waiting to be installed and had thought about picking up a negative buss bar to simplify routing a ground wire to the trailer frame. I've got one of the NoCo power inlets so I can plug an extension cord into the charger without having to...
So I am in the process of building a trailer dedicated for football tailgating. I'm at the point where I'm going to start electrifying the trailer with this basic plan:
Group 27 deep cycle battery to power:
Marine stereo
ARB fridge freezer
LED lighting
USB ports for charging electronic...
I feel your pain and had a similar experience about three weeks ago... 2005 LX470 that I have owned for about 5 years now with minimal issues. The truck was making a funky noise (at times) when you turned the steering wheel. I took it to a local Toyota dealership to have the gear oil changed...
If you drive the car it will stop blinking. Anytime you disconnect the battery the VGRS light will start to blink. Driving the car will reset the VGRS parameters.