My 1986 FJ60
Clean title in my name
She will pass smog with zero issue
220k Miles
Purchased as a bag of bones abandoned in Nor Cal from Joe Rawson and brought back to life using nearly all OEM when feasible with clean frame and a whole lot of...
Have a good pair of differentials from a 1988 FJ62 under 130k original miles. Front has the birfsoup mixture in it, needs to be cleaned with diesel or kerosene
Asking $250 each plus the ride from 11787 Long Island NY
Pulled from my 78 FJ45. Should be fine spline pinion. Needs brakes, little bit crusty but should clean up with just fine with blast/paint.
Asking $500 plus shipping. I can arrange shipping easily.
Located in Orlando
This is helpful John !
I don’t think this would work for Keith as I think he has a real early model ?
But I bet (John) you have gazillions of these stored
Daniel,
The 35" piece should do it for me. My passenger corner is the worst, you wouldn't happen to have a curved portion would you? Don't need much if any of the straight continuation from the actual curve of the corner, but a little extra...
Made a pleasant surprise recently. Packed with bondo on the tub lip, the preserved holes for soft top connectors.
They are definitely the right size. Six to a side.
Still have a ways to go clean up the tub edge.
I have a few rails, like the one pictured here, for either extending a tub or patching a section. No curb pieces
This one is about 35” long
Asking $50 plus the ride from 11787 NY
Might work for some one here;
What I have is a pair of custom cut OEM driveshaft under an early FJ40 frame with an FJ60 drivetrain and stock wheel base.
One side has the large FJ60 flange bolt pattern (68.5 x60 mm), the other has the shorter bolt...
Parting out an FJ40 build date September 76 here's the wiper motor and linkage. You know how hard these are getting to be. Price $190 plus the ride. Can send just the motor if you don't need the linkage it would be much easier and cheaper to...
Have a nice pair of warm hubs, not sure why the washers are grinded off, perhaps PO used a different hardware ? Hubs engage and disengage nicely
Asking $65 shipped conus