Next question for the community.
I have 2 t-cases. The one I'm rebuilding and a damaged one I'm taking parts from for this rebuild.
So I took apart my old damaged t-case and swapped the output shaft into the case I'm rebuilding.
Anyways I...
Hey Gary, should be no problem using any gears or shafts from other transfer case. Just has to be manual transmission case. Auto cases have a different gear ratio and I’m not sure where that occurs.
You got a full new bearing and seal kit?
If...
So I've torn apart a transfer case and I've come across what looks like a spun bearing
That journal bearing is supposed to be inside a big gear, but was stuck to the shaft when I pressed the gear off. It should look like this gear below.
So...
Appreciate the information. This trans is from a no history high mile truck. I would be more comfortable knowing the big bearings were replaced.
But if it is a sonofagun, then I'm not gonna try.
It just looked real simple on first inspection, 2...
I'm currently refurbishing a transfer case because of oil migration between the trans and xfer.
While I'm in there, I was wondering if I could replace any bearings on the h55f.
Is it possible to just pop the c-clip and replace the main input...