Just picked up my ‘19 after getting the 6112/5160s installed as well as SPC UCAs. I went with perch 4 and the standard rear Bilstein springs. Very pleased with how it turned out and the ride is both more comfortable as well as more controlled.
Hello All,
My wife's mother passed away and we have to clear out her storage unit in the Dallas/Frisco area - 10x10 storage unit and we have about 1/4 of that to move to LA
(a few wardrobe boxes and misc other boxes) There isn't anything fragile...
I've got the same set-up as you as well as the 3rd row. I swapped out the regular Bilstein rear springs for the HD ones and it's a noticeable difference. I'm happy with the stance and ride when loaded.
I have used pro clip mounts on my last four Land cruisers and have been fully satisfied. I’ve also also used them in a number of other vehicles of mine and my children’s. It is my go to every time. It actually works for me that the phone blocks...
I drove a gray 2017 today being sold by Beaverton Audi west of Portland OR. I'm hoping to save someone a little time by posting my report here. It seems to run and drive just fine but it's been used pretty hard by a family. Theres 30K or so...
I have mine below the right side vent @DallasTide
Zero dash panel gap in mine - been there for 2 years now. My only complaints are that it blocks the AC vent more than I'd like in the summer, I have to turn the phone a bit clockwise to feel the...
Just heard back from our insurance appraiser and adjuster, it's totally covered under the comprehensive policy. Dealership is ordering the parts they need to get her back on the road soon. Total cost with parts and labor came out to $8225.
Hope it works out for your insurance!!
If not, my guess is when you tell the Dealership your taking it somewhere else, they will try to make you a "deal" on the repair, rather than lose the $$ - then they'll sub it out for splicing into a OEM plug
1991 Toyota Land Cruiser HZJ77
HIGHLIGHTS: 70 series in the USA, 5spd manual, front and rear locking differentials, turbo diesel, CA title and registration and pre-97 no CA smog required.
This is a real 70 series heavy duty Land Cruiser from...
@ryanCA - not sure if you already have some cat guards, our raised LC's don't require a jack to get underneath. I've got the full BudBuilt skids so I don't need these.
There's still a group stealing cat's around SCV, I get the notifications on...
Love this - just about a year to early for me. We own a 2011 TE, my older sons, and will be looking for another
Good luck with the sale - super clean and built
If you end up deciding to repair the harness and the insurance/warranty/dealer doesn't work out give No Limit Baltimore a call. Their electrical tech can maybe even make you a harness . At least we discussed making harnesses when I was upgrading...
Got the quote of $8225 for the job, insurance is involved now. I’m hoping that this is covered under our policy. What’s messed up is our bumper to bumper warranty just expired a couple of months ago.
Believe it or not, soldering is not the best way to repair this. The cost of it isn’t the only reason there is no solder in our factory harness, a proper crimp is better for strain relief and avoiding problems in the future. The operative word...
^^^^^ This above is what I've witnessed first hand as well - rodents can cause an incredible amount of damage. If you happen to not catch it early, it's likely to grenade something super small that ends up being enormously expensive.