For Sale 1990 FJ-62 "The Raffle Rig" up for sale again

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Location
United States
Many of you are already familiar with this truck. It is a 1990 FJ62 that was rebuilt back in 2007 by the Rising Sun group and then raffled off to lucky guy, who I acquired it from. Here is the original build thread if you are not familiar with the story: https://forum.ih8mud.com/chit-chat/141677-1990-fj62-land-cruiser-being-raffled-off.html
I am the second owner of this wonderful rig. This has been a great truck for me the past two years (my daily driver), but I am moving on to others things. I will be sad to see it go, but hopefully someone will enjoy it as much as I have. I listed most everything I can think of. Let me know if you have any questions need more pics. The truck is located in Memphis, TN and I am asking SOLD will include the winch if I get my asking price.

Features:
· Clean rebuilt engine, axles, approx 30-40k miles ago (I do not know the mileage when it was rebuilt but it now has 266k on it)
· New radiator, water pump, thermostat, brake master cylinder/booster during the rebuild
· Oil galley plug done during rebuild
· Exhaust is 2.25” and runs over the frame
· Transmission and transfer separated cleaned and resealed
· Frame is rust free
· Arb air lockers front and rear with ARB compressor
· 4.88's gears

· Rodneys extreme valve body
· Slee Rear Bumper with swingout tire carrier (actual truck on Slee site) and not in production anymore.
· MAF 38 gallon long range fuel tank
· ARB Front Bull Bar

· 3.5" heavy/heavy Alcan Lift sits level with extended shackles in the rear.
· Front and rear swaybars and procomp shocks
· Castor shims installed
· 1" body Lift from Roger Brown
· Transmission Cooler
· Safari Snorkel
· 5-315/75 r16 firestone destination MT on 16x8 FZJ80 wheels painted metallic grey
· 1.5” aluminum wheels spacers
· 4 of the wheels have staun internal beadlocks
· Tinted windows all the way around
· New Sony MP3/CD headunit with AUX port
· New Sony speakers in cargo area and front doors
· Rowland front door seals
· Mechanical gauges installed under radio water/volts/oil pressure
· Trans temp guage
· Hella 4000's
· Tuffy console with cup holders.
· CB radio mounted to console antenna mounted on rear bumper
· Driver’s seat re stuffed with new foam from SOR
· Front and rear SOR Tuff Duck seat covers
· Rear Tuffy Pull out Drawer with Custom Built Deck
· Solid Rock Off Road Custom Fabricated bolt on step sliders
· 12v outlets in rear
· LED in the middle overhead light.
· Upgraded front headlight harness.
· Upgraded high and low beams lights to H4 and H1 bulbs from Ironpig offroad
· Fuse block mounted on the firewall
· AC is converted to 134, blows cold

Maintenance:
· New spark plugs and wires OEM
· New fuel pressure reg OEM.
· Rebuilt alternator
· New wipers
· New wheel cylinder


Extra parts:
· Factory service manual
· Grill with head light doors
· Master power window control
· 4wd vacuum switch
· FJ-62 license plate
· A box of misc. parts

Issues:
· The paint job is fading especially on the hood and roof. It needs to be redone.
· The tranny seems to shift hard just in the morning, was told that I should flush the tranny with synthetic, but does not bother me too much so I have not done this yet.
· There is a rip in the driver seat
· Small crack on the bottom of the windshield, has been there for over a year and has not spread.
· Rear power door locks work every so often.
IMAG0286.webp
IMAG0279.webp
IMAG0281.webp
 
Last edited:
I almost got this rig last time, I was #2 in line, ended up with an 80 series that has been more of a project than I was looking for.

good luck with it!
 
Everything you read is spot on. I was the lucky winner of the rig. Mark has taken and already nice rig and added a few more nice upgrades that really stand out. Well done. This truck runs amazing and especially on the highway. The Alcan Springs are great off road and have quite a bit of flex and soft feel for being heavies.


The next owner will not be disappointed.
 
Thanks for all the compliments.

I have gotten some great trade offers that are hard to turn down, but I am really looking for cash. I also want to mention that I would be willing to work on the price if the buyer does not want particular parts.
 
IIRC there were two offers. Both declined.
 
Back
Top Bottom