x

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

What is left to box if you have cut 4' off of the back?
 
If you're going to create a new crossmember in the front which will be the bumper, cradle the engine with a mount like that and put a mount in for the tranny and tcase, I'd stop there. The rear will be sufficiently stiffened for any articulation you are looking to get. Actually too much as you are running the risk of fatiguing the metal back there.
 
Last edited:
BTW, i fully boxed the frame in my 40.
 
LOL

Two eye bolts on the rear xmember???

(or where it was??)


Glad to see it get some use :D
 
It’s a pain to do with the tub on, but worth it. If you’re going to have the tub off I would weld it all up, front to rear, the rivets allow a lot of flex.
 
i boxed my entire frame in with 1/8 plate took a while and was a pain but its worth it. I cut out small holes in the top and replaced them with rubber grommets so i can spray waxoyl or atf fluid to keep it from rusting..the less frame flex the better, as metal bends it becomes weaker.


make sure you weld those extra cross members in then cut the stock crossmember to keep everything straight as best you can. You don't want the tail end of the vehicle chasing ya down the highway.
 
Back
Top Bottom