x

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I'm actually considering doing this with brand new emblems just to prevent drilling holes in my rear quarter (replaced quarters a few yrs ago, just not sure why I did it :bang:)
 
It's not a "repair" but you could use 3M emblem double-stick foam tape. You'd have to remove the other post using a Dremel but with a smooth surface the 3M stuff works great.
Did the same thing. works great.
 
JB weld for plastic or some type of epoxy and something like this for the retainer.


But I would go the 3M route it's how most modern emblems are attached.
 
Did this repair more than 15 yrs ago on my side emblems on my 40. This may sound hokey but it works & looks original from the outside. Sorry, I don’t have pictures. Got this idea from Hot Rod magazine.

1) remove your emblem...turn it over
2) carefully drill out the 2 posts that use to go thru the holes, DO NOT drill completely thru, just an indentation
3) cut the head off 2 appropriate sized screws
4) epoxy the 2 screws into the indentations you made in step 2
5) attach thru the appropriate holes, put a lock washer and a nut on you’re good. Doesn’t have to be super tight, just snug

It works, did this on both sides. After 5 years or so, one of the screw post did become loose, but it was an easy fix.
 
Back
Top Bottom