Wheel Spacers stuck!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 15, 2018
Threads
2
Messages
28
Location
West Virginia
First time having the front wheels off of my 80 and I found some spacers. No doubt to alleviate some tire rub. I’ve never seen spacers like this. I’m guessing they are steel and they mount with bolts instead of on the studs.

I don’t care to reuse them but I HAVE to get them off. I’m doing a brake job at all 4 corners as I continue my baseline. I tried a torch for as long as I had the guts, prying and even a hammer. Any ideas on how to get these out? At this point I’m figuring I’ll remove the axle and use a bigger hammer or break out the sawzall and chisel but I’m hoping it doesn’t come to that.

Anybody dealt with this before? Thanks.

7988BBC1-DBCE-4065-BCDF-320F3D1022A1.webp
 
That’s not a spacer. It’s the hub. The front rotors don’t slide on and off like you are (probably) used to.
 
That’s not a spacer. It’s the hub. The front rotors don’t slide on and off like you are (probably) used to.

I was kind of wondering about that. You’re right, I’ve never seen rotors that don’t slide off before. I didn’t go crazy with it so hopefully I didn’t damage anything. I have a downloaded copy of the FSM. I’ll dig through it to find the section I need. I figured it was no different than any other brake job I’ve done. This is a learning process for me. Thanks!
 
I'm glad you posted your question and got some help, that's what this forum is for. Good luck with the rest of your work.
 
Some here would suggest taking care of a few other things while you remove the rotors up front. Good time to fix any seals, replace bearings, put in new wheel studs (who knows how poorly they've been torqued over the years) and also it's just nice to know the birfs have been serviced and have nice new grease in them. It is more work but you will have it apart anyway and you said you are baselining it.
 
Back
Top Bottom