Welding caused electrical problems.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

@Brix 76
Post a picture of your alternator. It may be an "upgrade" to an internally regulated alternator, which is why you don't have a voltage regulator on your firewall. Is there a connector (like mine) at the firewall?
 
@Brix 76
Post a picture of your alternator. It may be an "upgrade" to an internally regulated alternator, which is why you don't have a voltage regulator on your firewall. Is there a connector (like mine) at the firewall?
That’s a good question and I actually called Bosch yesterday and they said that mine is externally regulated.
 
Yes...
None of my gauges (fuel, oil pressure, etc.) and my heater fan switch did not work. My speedometer worked. My lights worked.

I read lots on mud about the importance of grounds in the 40. I poured over @Coolerman electrical diagrams and cleaned up all of my ground circuits and also replaced my fuse panel. That fixed my issue and I’ve been up and running just fine for 3 years now!
 
It is possible you fried one or more of the three body grounds on the harness.
Quick ground lesson on your 1976 FJ40.
First ALL chassis grounds will be a White/Black wire. That is a white wire with a black stripe.
There are three of them, all easy to locate. Two of them are up near the headlights (one on each side) and ground to the inner fenders. The third is at the fuse panel and actually goes under one of the fuse panel mounting bolts. Electrically they are all tied together. See terrible hand drawing. Don't rule out blown fuses or as was stated above corroded fuse panel clips!
GroundCircuit.webp
 
i may have missed it , ?

but were both the positive and negative cables disconnected from the battery prior to any welding ?


🤔
 
Back
Top Bottom