Weird Starting Issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 29, 2013
Threads
39
Messages
176
97.

Intermittent problem of having to hold the ignition for it to start. It doesn't start immediately.

Sometimes it doesn't start at all and if I let it sit for a few hours it starts right up.

Acc and radio working perfectly without loss of power so I know it is not the battery. Replaced the fusible link recently.

Sometimes I have to hold the ignition for several seconds for the car to start.

Where should I start?
 
Sounds like a problem with the starter.



Sorry, couldn't resist....
 
Are you saying that the starter isn't cranking the motor or the engine is not firing when the starter cranks?

Nothing happens. I hear a click then nothing.

The dash lights all go off also.

This has been happening intermittently for 2 years.

I THINK it might have gotten better after I put in a new fusible link, but it's happening again. Once today and once a few months ago.
 
Yep. What he said.
 
Agree contacts, at this age, it's sometimes best to just replace it, have had best results with, DENSO 2800169.
 
Personally, I've had great success just replacing the starter contacts. Three for three in the cruisers I've had with the "click when I turn the key" issue. Cheap and easy.
 
I used to keep a hammer in my car to bang on the starter...until I replaced the starter.

Either way, you'll get where you want to.
 
I used to keep a hammer in my car to bang on the starter...until I replaced the starter.

Either way, you'll get where you want to.
I have been doing the trusty hammer trick recently. I guess its time to replace the contacts. Is there a specific kit to order?
 
Hammer is great until the contacts weld together. Then you better have a spanner to get the battery cable disconnected ASAP...

The OEM contact kit is cheap enough.

cheers,
george.
 
Starter contacts are easy. Also check your neutral safety switch. I had a similar issue. Pulled the wire connector off...then cleaned with electrical contact cleaner and compressed air. Others have had a bad connector/wiring. Also easy to investigate.
 
You mentioned the dash lights go out sometimes when trying to start. That sounds like a loose battery cable (pos or neg). Have you verified they are tight?

Next step would be to change the starter contacts and if it still does it, the ignition switch wire circuit is likely degraded. I have been this route recently a couple times and ended up adding the Ford Solenoid. 94 delayed cranking. Starter, ignition switch, or other?
Not one issue since adding the Ford Solenoid.
 
Last edited:
Agree w/Summit...OP's second post says dash light go off after the starter clicks, which is not relatable to bad contact at the starter. This screams of poor continuity at battery cables.

Suggest don't simply tighten battery cables, but first remove both, wire-brush the clamp IDs and the battery post ODs, then reconnect and give her a whirl. Check the other cable connections if this doesn't fix the problem.

Oh, and replace yer starter contacts! Because it's time.
 
I mis spoke the dash lights stay on.

I just replaced the starter with a reman denso and it is still not starting. Only hear 1 click. Gonna check out the NSS.

Any other ideas?
 
Cleaning the NSS saved me buying a new starter.
 
@Squash @Ken C NSS is hopefully the issue!!! I just went through the same problem. I was able to clean mine with contact cleaner...fixed my no start issue right away and it only took a few minutes.

There are several posts on here about wiring going bad as well. Some have replaced those bad pieces and swapped everything over to a new plug.

Let us know how it goes!!!!
 
@Squash @Ken C NSS is hopefully the issue!!! I just went through the same problem. I was able to clean mine with contact cleaner...fixed my no start issue right away and it only took a few minutes.

There are several posts on here about wiring going bad as well. Some have replaced those bad pieces and swapped everything over to a new plug.

Let us know how it goes!!!!

I have to check again, but the car doesn't start when in neutral either. Can it be the NSS switch?

So pretty much I have to remove all the grease that is on the inside of the connector? Is it not supposed to be there?
 
I have to check again, but the car doesn't start when in neutral either. Can it be the NSS switch?

So pretty much I have to remove all the grease that is on the inside of the connector? Is it not supposed to be there?

Having an issue with the NSS will keep the truck from starting in any gear. The purpose of the switch is to make sure that it is in Neutral or Park. When the switch itself is going bad or there is a bad connection, the NSS wont send the proper signal to the ECU allowing it to start.

As a quick and easy thing to do, clean the NSS connection. Search on mud here and there are a few posts of people that had corroded connections. I cannot say for sure if the grease is supposed to be there or not. But cleaning mine did get my truck going again. It only took a few minutes. Worth a try at least for you. Ya never know...
 
Back
Top Bottom