Weird electrical problem with my 80 - solved!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 26, 2012
Threads
98
Messages
4,702
Location
SacTown!
hey gang

I finally got a problem that's new thread worthy!

Recently I have been having electrical problem when cold starting after parked over night. The needle of the speedo wil drop and goes back to normal and engine light will flash. It seems to be that there is a temporary lost of power, I even can hear the clicks of relays. My clock would also lose its time.

So let @NLXTACY'S suggestion I changed out the alternator to a denso reman, tighten down all the electrical connections I can find and think of. The problem seems to get better for a bit then back to this weird problem.

Here is the video of it:


Help!!!
 
Qball
Even I can tell you, that's not the speedo.

This is the Speedo

prld.xlg.webp
 
I had something like that. It was the battery. It would start ok but the radio and clock lost presets
 
I remember the good ol' days when we'd get bikini pics of @Aloha Jen. Now we get dudes in speedos. FML!
 
If the battery is good, solid, the only power source that is common with Ign and clock is the black/blue circuit out of one of the fusible links to the under hood fuse box. A bad/intermittent connection in that area would take out the Ign switch (50A AM1 fuse) and dome fuse (clock).
 
So the harness looks good without cutting everything open.


My biggest mystery is that it only happens at cold start and fine after a couple of minutes. Think I'm going to revisit the battery even though it seems to hold charge fine at 13v.
 
I remember the good ol' days when we'd get bikini pics of @Aloha Jen. Now we get dudes in speedos. FML!
Got plenty of bikini pics, just tell the mods not to banish me!
 
So I cleaned all the terminals, contacts and removed all the accessories(winch, amp, aux) and still same thing! The mystery continues.

Phone a friend so should be able to try a different battery soon.
 
So the harness looks good without cutting everything open.

This unscientific approach has proved to not be an ultimately reliable form of testing for me :D

Not saying its in the harness there but ive unwrapped a few that "looked fine" to find crispy insulation and bare wires
 
Isn't there another spot behind the glovebox somewhere that the harness tends to get pinched and shorted? I've seen it mentioned in a few threads but I can't find one with good pictures at the moment.
 
Back
Top Bottom