Water Wetter Review

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 19, 2006
Threads
254
Messages
2,013
Location
Tulsa, OK
Website
www.cardomain.com
Cooling system addative from Redline lubricants: I had read this and that about it and watched the video on the Redline site, so I decided to give it a try. Directions say to put one bottle in for a standard size cooling system, so I put two.

The turbo builds some additional heat under the hood, (when ideling), on a warm day so I thought I would try it. I was skeptical, but I must admit the product works. The system definately runs cooler. How many degrees, I have no idea, but it definately works.

If you spend some time on the trail during the summer, or subject your vehicle to any other "low air flow" situation, I highly reccomend it. Even if you don't see the results I did, it still cheap enough to just write off.
 
water wetter just breaks the surface tension in the water, like soap does. I think I'll try some as well, thx for the reminder. I read that it reduces hotspots

also I found this interesting image
left- distilled water+redline ww right side- distilled water
after 4 days
test2.jpg
 
I've used it for years... Also another good one is Royal Purple "Purple Ice" .........
 
I've used it for over 10 years and put a bottle in every vehicle I own. Works good. Can find no downside to the product.
 
Is this a precaution for diesels? Or any and all motors?

My temp will rise when sitting still. Go down when moving. I tend to get worried when idling on a trail in the heat of summer.
 
By breaking the surface tension, I believe you get better contact between the metal and the water. In one of my college classes (long long ago) having to do with recovering oil from natual resevoirs, the degree to which the water was "wet" played a part in ease of recovery. "Wetness" was defined as a measure of contact from the droplet surface to the surrounding material.
 
Jet Dry?

I don't use a dish-washer much, but I figure it is less likely to foam than "cleaning product" surfactants.
 
i guess you can use a couple drops of HE detergent. minimal foam/suds. doesn't jet dry do the opposite? it's a softener right?

I heard people use couple drops of soap to improve cooling... i don't know anything about how much exactly.
 
I figured Jet Dry would have a sheeting action without foaming. I think it is to help sheet the water off the dishes before they dry, thus minimizing spotting.

When I did a search for surfactants and wetting agents, Jet Dry came up in some home photography sites, I think they use it as a cheap substitute for a treatment used to keep film from spotting up when it is dried after developing.

Guess I'll pick up a bottle and play around with it to see if it foams or not.
 
a higher concentration of puple ice will not offer any additional benefits,nor will it cause any problems. do not use distilled water in an aluminum radiator.

www.royal purple.com
purple ice.webp
 
Back
Top Bottom