Water Pumps for 2F's

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Trapper50cal

TEQ Frame of Mind
Supporting Vendor
Joined
Mar 22, 2005
Threads
120
Messages
8,205
Location
Durango, CO
Anyone know which waterpump a December 1976 2F comes with?
It does not appear to have an oil cooling system but I was wondering
If anybody knew how to establish for sure which pump is correct.

My guess: 1977 waterpump without oil cooler outlet.

(getting a 77 would make sure to circumvent August 76 breakoff)

any gurus know anymore?

:beer: :beer: :beer:
 
Your choices depend on what fan you have, too. Six-blade is direct drive, seven is clutch fan setup. Waterpumps are different bolt patterns. Both came with or without oil cooler.

Ed:beer:
 
Pretty good info here......

http://coolfj40.stores.yahoo.net/waterpump.html

Confusing part is that California got the clutch fan before federal spec trucks did (or something like that, I'm not writing a history book here:D ) or maybe it was the oil cooler. Coolers were optional on some years, etc, etc.
Just pic a setup you want to run. Also the 7 blade fan requires a larger shroud than the 6 blade direct drive.

Totally confused now? If you are.......sorry.


GL:beer:

Ed
 
It would be cool (pun intended) to use the fan set up thats on my F (single F) but will a 6 blade cool a built 2F enough?


All other things remaining equal, I don't see why not. Marksoffroad.net also sells an 8 blade direct drive fan that was standard on some FJs sent to Saudi Arabia. That ought to move some air.:D
 
I have a 76 California spec with an oil cooler and no fan clutch. I don't know if yours would be the same. I do know, that Cruiserdan was able to get me the correct new OEM Toyota water pump on the first try, and it's been fine for the 2 years since I replaced it. Be careful, though, as there are several variations right in the 75-78 time frame that are not interchangable.
 
Hi All:

Don't forget that there are different waterpump models used on the FJ40 and FJ55 models. These water pumps have different lengths.

Regards,

Alan
 
When I went from the F engine to the 2F, I continued to use my F waterpump. However, to make it work, I had to put in a fan spacer.

My cruiser runs at 180 degrees even here in the desert.
 
One of the differences is the flange for the pulley.
new pix 051.webp
new pix 052.webp
 
If its any help, I run a 5 blade fixed fan on my 2f and it stays nice and cool in our summer heat in aus. seems to work as good as my 8 blade fixed fan, but robs me of less power. Ps I'm surfing the site off my mob phone, technology blows me away!
 
i figured something out

I think.....by looking at the external oil filter receiver, i have ascertained which pump to use. I looked at the available oil filter "holders" and noticed a difference between that which is used with an oil cooler set up and that which does not. my oil filter "holder" (pardon my ignorance) looks like the one offered for systems that DO NOT have the oil cooler system which covers the California as well I believe, so mine in a "w/o oil cooler model" so I buy the one that does not have that option. Now fans and shrowds are a different matter. I'm suprised to read that the F waterpump worked though.
 
Back
Top Bottom