Water Pump '78FJ40

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Ive always used the blue permatex but i use fipg for oil. I also always end up buying new toyota bolts for the water pump since i can never seem to find the right length
 
All good guys, getting new OEM gasket and taking my time this time!!! BTW has anyone else had this type of fun intalling theirs??? I am putting it on with the hoses attached but not tightened up completely as very little clearance to install them later............
 
Hiya, usually it's an afternoon job once you got all your parts. I clean the bolt holes with a tap to make sure they go back in easy. I also clean the area with brake fluid to get all the old grease and gasket material off and then rub it down well with steel wool and then clean again to make sure the gasket and sealer sticks well. I have made gaskets from generic gasket sheets that you can find any most any parts store. I usually check the thermostat and look at the other pulleys, etc while I've got the radiator out. You'll be driving soon enough. Good luck!
ty
:beer:
 
Yep I did clean the surface very well
 
No reason you can't make up two studs (cut heads off old bolts) and run them in to help hold the gooped up gasket in place and align the pump at the same time. Remove the studs as you start the bolt up. Good luck.
 
I cannot take credit for this...
 

Attachments

Tomorrow am, will post up pics!
 
Got my bolts from Camelback Toyota.....super folks there!!!! Murf has been a BIG help in both my '78 and the '76 I recently picked up. While I was at it I blasted the pan below the radiator and sprayed and also sprayed with high temp gloss the radiator as well. Everything is buttoned up, no leaks and after she cools will add the coolant needed to bring her up to correct level. BTW I only got like 4
Pan1.webp
FPIG.webp
Rad1.webp
Rad2.webp
gallons out of her when drained the system, spec says just under 5 gallons so she hangs on to some of the cool.....in the block? Anyone else experience this??
 
BTW thanks everyone for the help:beer:
 
Usually any engine block will retain some coolant fluid until you find the block drain and open it. The block drain on an F motor is about 2/3rds of the way back from the front under the carb, and about 2/3rds of the way down from the top of the block. I'm assuming that a 2F is in about the same place. It is not uncommon for the coolant passage there to be either partially, or fully, blocked with a compacted sand like substance. I haven't done this yet, but others have had success reaching in there with screwdrivers/wires, or other similar objects to break up the blockage and get coolant to come out.

Don
 
Thanks guys! I like that Jefferson quote Don; seems our anti American government has forgotten the order of things and who put them there.
 
SO help me with this one guys................I am usually a stickler for labeling ALL nuts and bolts but when I ripped into taking out the radiator and all the other stuff to replace the water pump I neglected to label this nut and bolt. Anyone have any ideas where this may go? Been looking everywhere...:doh:
Bolt1.webp
Bolt2.webp
 
Will check it out again today after work and thanks Eddy!
 
Throwing this out there.....could that extra bolt be connected with the splash pan below the radiator you sandblasted and painted?

OR, just maybe, it was a long term missing bolt that settled in the bottom of that pan, that was finally found? :meh:
 
Back
Top Bottom