Valve cover bolt bosses

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 6, 2015
Threads
1
Messages
5
Location
Port Townsend WA
Owner 1978 FJ40, mostly restored. Need to learn the purpose of one 8mm and two 6mm bolt bosses on my OEM valve cover. These are not the two bosses for the air cleaner housing. I have a photo on my laptop but cannot map out how to get it in this post. Advice please! Thank you
 
Click "Gallery" above, scroll down to "Your albums" create album, them click upload media, then browse, then select image from your computer.
 
Thanks Mike! Photo of my 1978 FJ40 and the valve cover in question attached. I look forward to being a part of this Cruiser forum. In addition to my fairly decent 1978 FJ40 I have another 1978 FJ40 with a great completely original drivetrain and thoroughly rusted out body that I want to part out eventually. If you know people in our part of the world that might be intersted let me know. I am not trying to ride the FJ gravy train for lots of cash. I bought the parts vehicle mostly to use as a reference to get my engine compartment back as close as possible to OEM. Again thanks for the guidance getting the photos uploaded. Cheers! BMc.
1039480-ee7ab1516da1e00712040a89422a4276.jpg
1039479-bc8875b51262e48ea1b9e4c5745b6b23.jpg
 
Tysano : Thanks for the heads-up reply and great photos. I am pretty sure I have a good understanding of the air cleaner housing mounting points. In one of your photos there is a 6mm bolt hole at the top of a vertical, flat part of the casting just forward of the oil fill cap. This is one of the bosses I am trying to nail down. The photo from 73FJ40 clearly shows the other two bosses in question. Thank you 73FJ40. One of the holes clearly is meant to carry some hose or wire (size of clip makes me think vacuum hose). Any ideas on the other 8mm boss just above it? FYI : I am not trying to put together some kind of hyper-showroom Cruiser. Perhaps like a bunch of people out there I just want to understand as much as possible what I am working on! Thanks folks! This site is awesome!
 
Tysano : Thanks for the heads-up reply and great photos. I am pretty sure I have a good understanding of the air cleaner housing mounting points. In one of your photos there is a 6mm bolt hole at the top of a vertical, flat part of the casting just forward of the oil fill cap. This is one of the bosses I am trying to nail down. The photo from 73FJ40 clearly shows the other two bosses in question. Thank you 73FJ40. One of the holes clearly is meant to carry some hose or wire (size of clip makes me think vacuum hose). Any ideas on the other 8mm boss just above it? FYI : I am not trying to put together some kind of hyper-showroom Cruiser. Perhaps like a bunch of people out there I just want to understand as much as possible what I am working on! Thanks folks! This site is awesome!
The parts for these trucks were used in so many different markets and on so many different models it's hard to say what all the bolt holes are for
 
The two 6mm holes you are inquiring about are for anchoring the oil cooler line.

Best

Mark

www.marksoffroad.net
 
Many thanks for the replies. Thank you for the heads-up on the oil cooler. I think Tysano maybe nailed it : a Cruiser shipped to Thailand would be a very differently detailed vehicle than the one shipped to Vancouver, WA but both would have the same valve cover. Time to let this one go and put bolts in the holes I understand! Thanks to all! I look forward to being a part of the forum. BMc.
 
Back
Top Bottom