Turn signals

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

musthave

All maps, one app!
Supporting Vendor
SILVER Star
Joined
Sep 4, 2013
Threads
729
Messages
5,910
Location
Florida / Colorado
My turn signals blink fast on the dash. Left turn signal works in the rear but not the front. Right turn signal works in the rear but not the front.

I have checked the sockets and replaced bulbs both front and rear.

I have replaced the flasher relay.

With the hazard lights on I get a normal blinking speed on the dash and both of the rear signals work as they should. The front ones do not turn on.

What's The next step in finding the issue?
 
OEM bulbs or LEDs? Are the turn signals in your ARB wired up too?
 
The turn signals in the ARB are changed to daytime running lights. OEM bulbs.
 
Check through that front circuit for the bulbs. Somethi g in that harness must be messed up.
 
I will check the trailer wiring harness. I have pretty thoroughly checked the front harness out to each turn signal.
 
When less current is pulled through a flasher, there's less heat to make it peel away from the contact and so it resets faster. It blinks fast because the front signals aren't pulling current. Having the hazards on runs all the signals through that flasher, so it slows down a bit.

It's a bit odd that only the rear works, because the electrical system is separated into left and right. There really isn't a common 'rear' or 'front' ground for flashers, as far as I can remember. (bear in mind I have a '91 which might be a little different)

I would start by testing the front sockets with a DMM. Check for ground, then check for power with the signals on. If there's no power, the only common point remaining is your turn signal switch, which can be tested at the connector under the steering column. I put this last because being upside down in that position for a while is less than comfortable.
 
Last edited:
Just in case anyone refers to this thread in the future.. I had a little spare time and made this. I think two fuses are mislabeled in the first diagram.

S8bvyGK.jpg
 
Just in case anyone refers to this thread in the future.. I had a little spare time and made this. I think two fuses are mislabeled in the first diagram.

S8bvyGK.jpg

Sounds like you understand this stuff much better than I do. Where would I find these two fuses to check them?
 
When less current is pulled through a flasher, there's less heat to make it peel away from the contact and so it resets faster. It blinks fast because the front signals aren't pulling current. Having the hazards on runs all the signals through that flasher, so it slows down a bit.

It's a bit odd that only the rear works, because the electrical system is separated into left and right. There really isn't a common 'rear' or 'front' ground for flashers, as far as I can remember. (bear in mind I have a '91 which might be a little different)

I would start by testing the front sockets with a DMM. Check for ground, then check for power with the signals on. If there's no power, the only common point remaining is your turn signal switch, which can be tested at the connector under the steering column. I put this last because being upside down in that position for a while is less than comfortable.

I am going to go through this process tonight.
 
Do you have the Original junk trailer hitch connector stuck to Rear RH Fender?
Mine was messing my blinkers all up.
Ripped it out and bought the Kurt (made in USA).
 
Where would I find these two fuses to check them?

The TURN fuse is in the middle, third down (position #8) in the main fuse block to the bottom left of the steering wheel. GAUGE is just above that. The diagram doesn't show it, but the wires for the front and rear are spliced together after the turn signal stalk, so there's really two bulbs and two grounds instead of the one shown, in addition to the dash indicator lamp. If the fuses are dead, nothing works at all. My money is on a weird double wiring failure.

Good luck mate! Electrical is always fun. When I first bought my rig all the lights would randomly go out at night and the hi-beam indicator was dead so I blinded a cop at 2AM :D
 
Back
Top Bottom