Went off-roading to Wheeler lake yesterday. Truck did great but now my turn signals and hazards are out. Dead all around. No green arrows inside. No clicking and no light outside. Maybe a loose wire because it momentarily worked but I lost it again
Turn signals out
- Thread starter 713Ace
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
John, for your 2011 (put year of vehicle in signature) 
may be Flasher relay.
Here is location
Thread on install
forum.ih8mud.com
Toyota Part number 8198032010
Autozone has it for less if you want it today
Not sure if thats your problem though as what I read says flashers blink faster than normal
Anyone else have an idea?
may be Flasher relay. Here is location
Thread on install
Flasher Relay Replacement
I ran my hazard lights for about and hour last week and it burned out the Flasher Relay. I got the new relay today and I started rooting around under the dash to figure out where it went. After unsuccessfully looking around for a few minutes I gave up and looked on the forum. I found a couple of...
forum.ih8mud.com
Toyota Part number 8198032010
Autozone has it for less if you want it today
Not sure if thats your problem though as what I read says flashers blink faster than normal
Anyone else have an idea?
- Thread starter
- #4
John, for your 2011 (put year of vehicle in signature)
Here is location
View attachment 2376709
Thread on install
Flasher Relay Replacement
I ran my hazard lights for about and hour last week and it burned out the Flasher Relay. I got the new relay today and I started rooting around under the dash to figure out where it went. After unsuccessfully looking around for a few minutes I gave up and looked on the forum. I found a couple of...
Toyota Part number 8198032010
Autozone has it for less if you want it today
Not sure if thats your problem though as what I read says flashers blink faster than normal
Anyone else have an idea?
Ken, that was it. Only had to do a slight dremmel modification to get the bracket to fit on the new relay (for some reason the new bracket mounted on the opposite side than the old one). Followed the thread and good as new. Thanks for the help!