Turn signal question!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Pin_Head said:
In retrospect, these bulbs may not be a good idea if they aren't bright enough. You don't want to get rear ended in the fog because your tail lights were too puny.


I have HUGE LED tail/stop lights.

I have little turn signals.

This rig doesn't see much street duty.
 
Pin Head, If I wasn't a heterosexual male I would kiss you.

I went to the Auto Zone and bought a variable load electric flasher, works PERFECT.

Thanks for the help.
 
Why didn't you just wire the LED stop/turns/tails as turn signals as well, probably would have saved you a headache or too since you ended up using one of the neccassary parts anyhow. add a couple diodes or a trailer wiring converter and your LEDs will do three functions;)

No biggie, just something for you to try later on at this point. Too bad you already have an extra hole in your bumper :(

Good luck.
 
So with the electronic flasher you can run stop,turn and tail with only 2 lights? I think I'm going to do that! I have 2" round puny little turn signals that are hard to see. I think I'll just put clear lens lights in the 2" holes and use them for reverse lights.

So I just ask for a variable load electric flasher?
 
landcruiserrich said:
So with the electronic flasher you can run stop,turn and tail with only 2 lights? I think I'm going to do that! I have 2" round puny little turn signals that are hard to see. I think I'll just put clear lens lights in the 2" holes and use them for reverse lights.

So I just ask for a variable load electric flasher?

You also need a trailer wiring converter or some diodes. This makes the blinkers blink while braking, current won't flow back to the othere lamp with the diodes or little black box in place.

Good threads on here by helocat, outlines a very good install of LEDs try searching for it if you need a better idea of the whole thing or a good diagram. if you buy the trailer converter, the instructions included with it are very simple.
 
I know this is after the fact, but I just went through the same thing. It was actually due to the wrong light bulb. The part monkeys kept giving me what their computers and books listed for the front blinker of my 1969 fj55, and none of those bulbs had a watt rating on them. I ended up finding the right bulb 12v, 25 w, and it works now. Even and 18W bulb would not work.
 
Back
Top Bottom