I'm needing a break capable of folding a 30" pice of 16ga. Anyone have one or access to one?
Tool needed
- Thread starter kc_chevota
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I have gone to metal cut to length out in olathe, (drive around back) and they let me use theirs for a few dollars.
- Thread starter
- #3
Kelly is it a solid or finger break? hopping to find a finger type
Yes it was finger.
I did 14 ga. on it and it was a lot of work, but 16 should not be an issue.
I did 14 ga. on it and it was a lot of work, but 16 should not be an issue.
- Thread starter
- #5
whats a few bucks 5 10 20? will need to make 2 pices 3 folds each, so like 15 min of work. dont want to over pay or insult them.