The Mall Crawler PM thread

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

SmokingRocks

hopelessly addicted to Cruisers
Joined
Oct 6, 2014
Threads
116
Messages
4,111
Location
Colorado
So I picked up this 230k mile 93 single owner a while back for 1200 bucks. Pretty well maintained.

Today I just replaced the front crank seal and oil pump seal. While doing so I went ahead and drained the radiator. This radiator is an aftermarket one (not sure what brand), it has a metal top and bottom tank. Anyway, when I flushed it I noticed a bunch of white fluid coming out. Then when I inspected inside the filler cap hole I noticed the fins are pretty well crusted over with calcium buildup.

I've read plenty of threads about CLR, vinegar and other cleaners but is it ok to use that approach with the 1fz?
 
CLR will desolve magnesium, I don't know If there Is any In the engine or cooling components. I would do some more research proceed with caution. Good Luck..! :)

Barnacle Buster ® Concentrate | TRAC Ecological

This may work better, barnacles are like Cement, LOL
 
Last edited:
You can bet that the rest of the cooling system is compromised. Sounds like the PO used alot of regular tap water. Use EVAPO RUST THERMAL CURE and flush coing system. Ive used it on several cars with excellent results.
 
How did calcium get in the system (hard water used instead of distilled) or is is the breakdown of aluminum when the Antifreeze lost is ability to buffer PH and became acidic?
Doubt anything your going to do will "Clean" the system. If you get PH back where it is suppose to be that will provide longest life.
Make sure you mix up your next antifreeze with distilled water.

 
As stated I bought the vehicle recently with 230,000 miles on it. I have no idea what the po did, they likely used tap water when diluting their coolant which lead to this mineral buildup. I know better than that and none of my other cars radiators look as calcified as this one.

The radiator is one thing, its easy to replace. I am more concerned with the buildup inside the block and heater core. CLR and vinegar are acidic and will dissolve/break up calcium deposits, pretty basic chemistry. But it also will start eating aluminum and brass if left in too long or not fully flushed out.

I was hoping to see if there were some people here with experience doing this on the 1fz-fe. Or if there is any material within the system (perhaps even the hg) that would forbid this type of wash.
 
I had just replaced my radiator with a 3 core CSF off amazon because the hose bung on top of the factory broke while attempting to swap fan clutch. Ended up plugging up bung & hose to be able to drive it until parts came. I bought the 2 different system flushes at my local NAPA, 1st one instructed 15 mins to 3 days so I drained my rad & block & put it in with h20 for three days (hr long drives with heat + rear heat on) and drained and flushed. Followed that up with the other more instant results flush and cleaned system out with water. This changed my fluid color from poo brown to clear green. Don't recall product names but they only had 2 & both were 5-6$ range. Good luck
 
Back
Top Bottom