OK thanks
Tech Questions Here (5 Viewers)
- Thread starter Volunteer
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
^x2^
BTW, anyone running the TG Bomb Proof motor or t-case mounts? I need a new t-case mount and figured I would do motors too.
BTW, anyone running the TG Bomb Proof motor or t-case mounts? I need a new t-case mount and figured I would do motors too.
Have both, but only installed the Tcase mount on the PU with no issues yet.
I'm just worried about the amount of vibration from the motor mounts on the road.
I pulled the 22re out and one of the OEM mounts dropped its rubber on the floor. Now I want to go with something that can't come apart.
Sent from my Samsung Galaxy Skyrocket S2 using IH8MUD for Android.
I pulled the 22re out and one of the OEM mounts dropped its rubber on the floor. Now I want to go with something that can't come apart.
Sent from my Samsung Galaxy Skyrocket S2 using IH8MUD for Android.
I can put a picture on my page from my phone, I can copy it. But I cannot paste it
Oh I have the skyrocket
Paul,
I'm having trouble figuring out exactly how I need to setup the power steering on the 3L, do you have it on your 2L? I'm trying to figure out if I can have power steering and the alt/vac on the passenger side.
I'm having trouble figuring out exactly how I need to setup the power steering on the 3L, do you have it on your 2L? I'm trying to figure out if I can have power steering and the alt/vac on the passenger side.
not sure will try mañana go look& take a pic or two.
Ok, TY. I think I will end up having to get a driver's side pump and bracket.
- Thread starter
- #2,010
Found a few good useful diagrams while wiring the Super Winch/Albright solenoid this past weekend. I have the newer 5 wire remote so it was a bit different than the write ups I found in the forums and on YouTube.
Useful info thanks, I have the 5 wire plug also. Put a copy in your glove box.
ditto
what exactly is that? some sort of home made winch control made with ford solenoids?
- Thread starter
- #2,014
BikerTrash said:
New high amp solenoid bud most manufacturers are switching to this setup away from the multiple solenoids.
Does anybody in the club have a tubing bender? While I'm doing all the renovations on the 4 runner I'd like to do some cage work.
Hey, we're in the same boat. I'll be doing a bit of exo later this year. Right now, I can be a little with an HF bender and wet sand, but I'll probably be looking for a good deal on a real bender because the sand process takes way too long!
Looks like a few members could use this.
Air / Hydraulic Tubing Bender with 1 5/8" 180 degree die INCLUDED - Great Lakes 4x4. The largest offroad forum in the Midwest
Air / Hydraulic Tubing Bender with 1 5/8" 180 degree die INCLUDED - Great Lakes 4x4. The largest offroad forum in the Midwest
Wheres the best place around here to get a roll cage built starting the planning now need to find a good person to do the work?
- Thread starter
- #2,019
1980toyota4x4 said:
Don't know anyone off the top of my head bud but maybe touch base with Brian at Cajun Offroad for a recommendation.
Been there once to try and get some work done set up one of those next week deals never herd from him and never answered his phone. have herd good things.