Builds Tagged '67 LV build
- Thread starter crustycruise
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #262
Same for the tranny case and e-brake before dropping off at local shop for rebuild.
- Thread starter
- #263
cont'd
- Thread starter
- #264
Back to the doors, start with the least-bad passenger front.
- Thread starter
- #265
cont'd
- Joined
- Apr 14, 2004
- Threads
- 1,473
- Messages
- 36,805
- Location
- 818-953-9230
- Website
- www.marksoffroad.net
It’s like Christmas when all the pics come at one time!
Fantastic attention to detail on those doors.
Did we talk about the dual seal option for the speedo housing?
Fantastic attention to detail on those doors.
Did we talk about the dual seal option for the speedo housing?
Don’t make it too pretty Don you won’t want to drive it.
- Thread starter
- #268
It was a case of saving worst for last with the driver's front. But no doubt that it benefitted from experience gained on the prior 3. Lots of detail here, but I think you'll appreciate the work the shop did enough to keep your attention.
- Thread starter
- #269
For the first time one of the doors had issues extending up into the ribs. Fortunately we were able to find some donor metal.
- Thread starter
- #270
No surprise, 50 year old donor metal isn't usually plug-n-play.
- Thread starter
- #271
... but you can make it plug-n-play
- Thread starter
- #272
I love it when a plan comes together.
- Thread starter
- #273
cont'd
- Thread starter
- #274
I don't recall speaking about a dual seal option. I owe you a call anyway about the center arm and drag link, so we can discuss it then.
- Thread starter
- #275
Don’t make it too pretty Don you won’t want to drive it.
That won't stop me driving it! But as nice as those doors turned out, I will be parking in the remote-remote lot to avoid dings! Good exercise too.
- Thread starter
- #278
Quick question if I may. I have 2 LV oil baths and notice there is a difference between the intakes - pics below. Can anyone clarify which would be correct for a '66 model year? Thanks.
- Thread starter
- #279
More progress to report - frame is painted! Close inspection revealed a few custom holes to weld up.
- Thread starter
- #280
It's been a mild winter so far in NC, good conditions for blasting.
