Stupid Head Gasket

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 7, 2004
Threads
36
Messages
144
Well, while getting my Lx ready for a Thanksgiving road trip I notice it was a bit low on coolant, resevore empty and radiater maybe 1/2 inch low. Imediately got a bit concerned so I started looking around and found some nice coolant leakage dripping down the drivers side of the block. Luckily it wasn't a complete failure leaving the family out in the snow here in Buffalo. Will feed Dan's dogs on Monday and will try to get a hold of the DVD but I am wondering what else I should do while I am in there. PHH is a given. Thinking about milling a little off the head but I am not to sure what that entails on my part other than dropping it off at a shop. Also, how long can I expect to be in there, I am pretty mechanical when I know what I am doing but unfortunately I don't know much about engines. I am hoping that with the FSM and the DVD I should be in pretty good shape. How much am I looking at spending here in parts and how much for milling the head?? Well I am off to the search button.

Thanks guys
 
Yeah, there's a wealth of info on this, do a search and look in the FAQ.

The milling will cost you depending upon where you are I guess. Mine was $495.00.
 
Checking the main harness by the EGR valve since you will have the extra room....
Checking the timing chain guides
new valve seals
ARP head studs (2JZ-GTE)
dremel/lightly polish to help oil return paths/chamfer the holes in the head.
set valve shims
decarbon the head/intake
new injector seals and check the connectors

Or you can just replace the head gasket and bolt everything back together and continue driving.
 
Back
Top Bottom