Starter Replacement Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 18, 2016
Threads
2
Messages
12
Location
Johnson County, Texas
My starter went out yesterday and I have removed it and obtained a Toyota remanufactured one. From what I have read on here now is a good time to replace the PHH and the fuel filter.

Is there anything else I should consider checking or replacing while I have the starter out?
 
The engine oil.

I would replace that fuel filter with a gun to my head. Otherwise, it stays where it is.

The hose replacement is overrated, IMHO.
 
The engine oil.

I would replace that fuel filter with a gun to my head. Otherwise, it stays where it is.

The hose replacement is overrated, IMHO.
If you knew what I was doing on an airplane today at work, you would see the humor I find in your statement about the fuel filter. PHH? Bring that on too!
 
Last edited:
My starter went out yesterday and I have removed it and obtained a Toyota remanufactured one. From what I have read on here now is a good time to replace the PHH and the fuel filter.

Is there anything else I should consider checking or replacing while I have the starter out?
If you decide to replace the PHH, consider doing the “work around” with a single length of Gates heater hose from the outlet on the head strait up to the heater valve plumbing.

This is a 30 minute task and also eliminates two of the 4 hose clamps you now have along that water path. Less clamps = less possible leaks.
 
^this

There were two versions of the cooling system. One (ours) was listed as the cold weather spec. The warm weather spec simply left out the tee near the water valve. And, of course, everything downstream of that.
 
^this

There were two versions of the cooling system. One (ours) was listed as the cold weather spec. The warm weather spec simply left out the tee near the water valve. And, of course, everything downstream of that.
Interesting. HOW do you know this kind of stuff?
 
It's listed on the catalog pages.
upload_2018-3-7_14-13-18.webp
 
I will be week after next. ;)
So your getting your A&P Lic. are you going to go the extra mile and get an IA to go along with your A&P? I've owned a few aircraft, having friends who had both A&P, and an IA saved me big time on biennial inspections. Plus they allowed me to do all my own repair work while they signed off on the log books.
 
Last edited:
With starter removed and wheel removed it's not that hard to do the PHH too. Do it / don't do it, either way. It's not as hard as most people think.
 
OK. I'll bite. What does the wheel and starter have to do with the heater hoses? They're on the other side of the transmission.
 
OK. I'll bite. What does the wheel and starter have to do with the heater hoses? They're on the other side of the transmission.
When I did the head gasket, the coolant drain plug was more accessible when the wheel was off.
 
Yes, but that's not the heater circuit, it's the block.
 
So your getting your A&P Lic. are you going to go the extra mile and get an IA to go along with your A&P? I've owned a few aircraft, having friends who had both A&P, and an IA saved me big time on biennial inspections. Plus they allowed me to do all my own repair work while they signed off on the log books.
I wish I were just now getting my A&P, that would mean I’m 30 years younger than I am. I have worked for United Airlines 28 years now. I’m simply transferring from SFO to PDX.
 
Back
Top Bottom