Starter/fuel pump cutoff switch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 8, 2007
Threads
59
Messages
2,101
Location
Baton Rouge, LA
I searched didn't find much on this.

Has anyone installed a fuel pump or a starter cut off switch?

Fuel pump power wire interrupt would probably be the easiest to do, but would still allow the vehicle to start and possibly drive for a very very short distance.

Starter interrupt might be a little harder to do. Anyone have a picture of which fuse is the starters?
(My FJC was broken into about 2 weeks ago. So along with eventually getting an alarm installed, i am looking to theft proof the 80 as much as possible)
 
Last edited:
It would be super easy to switch the EFI main relay logic. It would allow the truck to crank, but not fire. Biggest problem would be locating the switch both where it's convenient and hidden.

One thing that I did (many years ago) was to use any existing switch that throws a relay. You can use that relay to hit a "one shot" that stays energized as long as there's +12 feeding it.

No aftermarket switches, nothing to hide, nothing to search for.
 
That's why I like and have kept the factory alarm system. Already has a starter interupt switch. In my old Toyota mini-truck I had a fuel pump interupt switch that was hidden. It allowed the truck to start but it never would have gone anywhere. The truck would run for about 2 seconds and that was it. I would imagine it would be the same thing for the Land Cruiser. No pressure in the fuel system and it's not anywhere fast. A carburated engine with fuel in the float bowl might go a little farther.

The nice thing about a fuel pump cut off switch is the theif will think there's a mechanical problem as opposed to a theft deterent system he to find, when the engine runs, then quits, so he is more likely to give up and move on, than try to defeat the system and continue stealing the rig.

A great way to really disable your rig in a pinch such as at a trailhead or someplace remote, is to remove the EFI fuse. Only takes a few seconds and the theif isn't likely to think about it. It's not convienent for daily use, but very effective and only takes a few seconds.

I don't worry about my rig driving off without me. I'm more worried about it getting broken into and trying to figure out ways to defeat that...which is not easy.
 
Interrupt the fuel supply line from the injection relay. Fit a latching relay and use a hidden reed switch behind somewhere on the dashboard, door panel, sun visor, in fact anywhere you want. Get in car switch on the ignition and pass a small magnet over X area, the reed switch will close momentarily and activate the relay, you then start the motor and drive away. When you switch off the ignition the latch on the relay deactivates and the motor is immobilised. For a couple of bucks it is cheap and easy to install.

The only thing you should use is a diode suppressed relay or put a diode over the terminals 85 and 86, you may already have a relay where the diode is inside? If you wire terminal 86 to live and 85 to earth then you will be fine, the diode suppresses spikes from the relay when it deactivates, most will say don't bother but better to be safe rather than sorry, and this thought should really be applied to any relays fitted regardless of where it is on the car and what is it being used for.

regards

Dave
 
Back
Top Bottom