SS Brake Line Lesson

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Brentbba

Former Golfer
SILVER Star
Joined
Mar 27, 2003
Threads
449
Messages
11,094
Location
OC, CA
Being a 1/2 :banana: mechanic please school me on these.

Which or both to replace the rubber brake lines that are now over 12 years old.


Slee Off-Road Frame to Axle
Brake Line Kit

Slee Off-Road Axle to Caliper
Brake Line Kit
 
I just did the framw to axle. I did it for the extension. The calipers don't matter for that and you could use OEM for those.

If they are cracking and look bad, do all.
 
We were just discussing SS brake lines on a BMW forum - seems the concensus is that rubber are actually better for the "I don't want to deal with it again" crowd. The reason being that grit gets inbetween the SS wire and the teflon/poly tubing and accelerates wear. The only defense was shrinktube over the wire. The general feeling was that with SS lines that they were a 2 year replace item in the autocross crowd.

Also -AN fittings were the way to go, and the crimped design wasn't as good, but strangely the -AN type aren't DOT approved, so in reality you were better off going with non-DOT approved lines.
 
Slee's lines come with a plastic coating over the braided ss which should help with the dirt ingress. However on one of mine the plastic coating has begun to separate where the plastic meets the fitting.
 
Perfect timing for this thread. My caliper lines have been replaced with SS but the axle lines are rubber and cracking. I was planning on calling Slee tomorrow and buying the SS for the axle.

I've heard the same argument before in the BMW forums and while they have a point, I'll probably go with the SS and "try them out". If I have to do the job again in a few years, that's fine. It's really not a big job with a power bleeder.
 
JMHO-For the hard line to caliper-I would run Toyota OEM. Cheap and they last a long time.

For the frame to axle (3 lines) I would get Slee's stainless kit.


There is also an extended rubber line from Napa-Alvaro will have the part #- that has the unusual female-female configuration you need for the right side frame to axle line. The Slee kit, though, is highly reccomended.
 
Back
Top Bottom