Spring Spacer's?

[cruisertom911]

I'm good for a set. Been looking a MAF and talked to Slee's shop yesterday. He's got some as well, but metal one's from you...well, ok. How thick are we talking? Don't want to go much over the 30mm at this point. Thanks in advance.

 

[GXO]

I am going for 6" springs...no more spacers!

 

[Skim]

LT- I'll buy a set, I want a 2.5" spacer.

 

[e9999]

i have both a 1.5" and a 2.5".

still have to decide which one I'll keep...

 

[tommyd]

I'm also looking for a set of metal spacers if anyone is still thinking of making some. . .

 

[Trunk Monkey]

Fair warning LT, the last batch I made I had a dozen people that "wanted" some and only about 4 came through. Took me another 6 months to get rid of the remaining ones. I'd suggest $$ upfront.

 

[Capocaccia]

Im down for a set. Id put a down payment on them too. But I suggest you get these done soon if you are because christmas is coming!

 

[concretejungle]

How many of you guys are looking for the metal spacers? If there is enough interest i'll get some laser cut and i'll weld them up.

I'm also interested. Can the same be done for the rear?

 

[concretejungle]

Took me another 6 months to get rid of the remaining ones. I'd suggest $$ upfront.

That does suck to have to hold on to a few, but 6 months to sell out doesn't seem too bad to me.

 

[Trunk Monkey]

That does suck to have to hold on to a few, but 6 months to sell out doesn't seem too bad to me.

I think MAF and Slee had made rear spacers, don't know what they looked like. Only ones I've seen are the OME trim packers, just poly discs that sit on the top of the spring.

Floating the $$ to make them and then have people that were "all over it" fall through sucked. On the flip side, it would suck too to fork over some cash to someone and cross your fingers that they fab the item and come through.

 

[BRKLYN1]

I can make these for you in 1" - 2" in .25 inceraments any time. PM for details

 

[LT]

Fair warning LT, the last batch I made I had a dozen people that "wanted" some and only about 4 came through. Took me another 6 months to get rid of the remaining ones. I'd suggest $$ upfront.

Tis okay we get lots of parts that are laser cut for our products at Metal Tech that sit on the shelf. The set I made for Mark's 80 I just used 1/4" plate with a 3" tube in the middle for a total of 2"s. Leveled his 80 out perfectly.

 

[Trunk Monkey]

That's all mine are, couple of plate tear drops and 4" sch. 40 pipe however tall you want it.

 

[Bob_Garrett]

If someone decides to have some made, I'm in for a set. I'd be willing to make a down payment if necessary.