Slider design and materials

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 15, 2007
Threads
89
Messages
478
Location
30°54'01.53N / 84°04'56.04W
Im planning to build my own sliders and have a couple questions.

What do you all recommend for the thickness of the tubing that secures the 2x4 box pipe to the frame? Is 2" 11 guage tube sufficient?

I have access to free steel, but the 2" tube looks thin...but I dont know tensil strength of steel, so it may be more than enough. Would thicker walled 1" box tube be more stable?

Also, would designing the slider where the 2x4 box is sitting like \ be "more better" than just _? Seems that it would be more resilent to dents and also less surface area to drag over stuff.

Thoughts and opinions requested!!!
 
I built mine exactly as george's design dictates. I can't remember the thickness of the steel, but he had all the specifics on his web page. I do not have it saved any longer, but i'm sure someone will chime in with the info.
 
I built mine exactly as george's design dictates. I can't remember the thickness of the steel, but he had all the specifics on his web page. I do not have it saved any longer, but i'm sure someone will chime in with the info.

Have pics???
 
I used 11 gauge 2x4 and I can jack one side of the car up with a high lift jack. The sliders do move up and rest on the pinch weld when I jacked it up with the wheels off the ground and the jack contact patch did not dent the steel. The slider normally sits .5 to .75 inches below the pinch weld at rest. I also had to lower the sliders from the first time I built them because they would vibrate on the pinch weld under hard wheeling. So, don't try to build them up real close to the body (less than .5 inches) or you will be doing it twice like me.

Besides my little clearance mess up, they work great and have saved me a bunch of times. Thanks again George!
 
I build my own sliders and you can see a ton info and detailed pics of how I built them. You will see in the post that I built two sets, one for an 80 with side-by-side cats and one for my inline cats on my 97. You can find the post here: https://forum.ih8mud.com/showthread.php?t=133728

Here are a few pics.
drivers back to front.webp
1997 sliders.webp
slider final lower side mud.webp
 
Zane, those are VERY nice indeed.

Here's a few pics of mine. I ended up putting undercoating on them. I wish i would have gone with a flat black semi gloss instead.
cut n turn mod 001 (Medium).webp
cut n turn mod 004 (Medium).webp
cut n turn mod 002 (Medium).webp
 
Back
Top Bottom