sad note from a friend

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 28, 2004
Threads
157
Messages
2,023
Location
Norwich, VT
:eek: :crybaby: :eek: got an email from a friend - he's got a '94 80 series just like me.

Here is what the note said......

"The truck died yesterday on the way into work. The last mile sounded
like it was running on 2 cylinders. Got it into the garage at work but
when I went to try starting it it sound like pistons,rods and bearings
knocking all over the place. It gets worse.

Had to tow it out the garage with a jeep. Then watched them cart it away on
the back of a tow truck to ___________ Toyota $$$$$$$$$$$$$$$$$$$$.

Have not heard yet. Hope it's not terminal."
 
Ouch... that's not good.

Hopefully the dealership will throw in some complimentary ky.

Good luck to him though!

-Tim
 
new block and labor with a new radiator and all hoses is north of 6 grand...

I found out the hard way too.
 
:doh: Sounds like bearing failure to me:confused:

Any which way you cut it, thats gonna be big BOO YAA :crybaby:

Did he notice any oil pressure failure???

High water temps???
 
sounds like a good candidate for some sort of neat swap to me.. :)

My initial thought as well.....I'm sure he'll share what he finds out later/tomorrow - the last thing he told me was "they just rolled it into the bay"
 
"Head gasket. 285 for parts 2300 labor."


That's the latest.
 
Sucks that it broke down. But it sounds like its time for diesel power!!!!!!!!!!!!!!!!!!!!:)
 
howza bout a moment of silence..................................................................................................................................................................................................................
 
"The truck died yesterday on the way into work. The last mile sounded
like it was running on 2 cylinders. Got it into the garage at work but
when I went to try starting it it sound like pistons,rods and bearings
knocking all over the place.

Don't forget guys,

Pull over NOW if you have serious symptoms. Don't worry about blocking traffic; don't "baby it" (whatever that means :rolleyes:) another mile or two, or even another block or two. If it's unsafe to pull over, that's one thing. But if it's safe to pull over, pull over NOW!.

(My wife knows this.:))

Curtis
 
Seconding Curtis on that. When things are amiss in the engine bay to the degree that a driver is aware of vibrations or rough running or loss of power, it's because carnage is seconds away. Stop immediately, let the engine cool and assess it. One way to look at it is the few minutes of running an engine that's showing perceptible stress cost about $200 a minute. Don't spend the money - shut 'er down.

DougM
 
$2300 for labor . . . Sad day. :frown:
 
The standard response from the ripperships is going to be a high$ figure to see how much they can extract from your wallet. Doesnt matter if its a tercel or LC. How many hrs does the HG take ? Take it to someone honest not someone you already know isnt.
Had a 87 4 Runner I bought new , this happened in probably 91 or so. It was running fine one day , next day it had a dead miss, looked at the obvious didnt see anything wrong. So like a dumb a$$ I thought I would "do the right thing" and take it to the dealer to get fixed. Next day they already have the head off of it and say it needs a total rebuild or new motor at the tune of $2500, Running fine two days ago now its dead. Hmmm I may have fallen off the turnip truck hit my head and suffered irreversable dain bramage but aint quite that desparate to give you my hard earned money w/o a 2nd opinion and frankly dont like your condescending attitude. So I just had to tow it home and go from there. Took it to a local garage, and he said since they had already taken it apart he couldnt really diagnose anything as it sat in pieces so he reringed it , put in new bearings for $750 total, got it running and it had the same miss it had when I took it to the stealer. Took his mechanic 15 min to find a broken injector wire, fixed it and was running perfect. Now thats another fine story for never taking your vehicle to be worked on at the dealer, probably any brand car. I know all arent like that but theres just too many horror stories out there.
Now take that cruiser to Proffits or somewhere and put a 4BT or NPR diesel in it and know you made a good decision. Run bio or WVO and save some money on fuel.
 
I don't think my friend has the ability of taking it off the road for awhile. Sadly this lack of ability will prove costly no doubt. Were it me I'd tear into myself and have it back running in great shape...My effort would be similar to Dtaylors but it probably wouldn't be as thorough as colorful, would cost more and take an additional 3 years.
 
Back
Top Bottom