Rusted frame----- fixable ?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 7, 2020
Threads
5
Messages
28
Location
Gatineau
Hey guys I'm getting ready to sand and paint my frame and the inner c channel in some sections is rusted pretty bad ... What's the best way to fix that , the proper way?


I saw many treads about it here but it all seemed like the frames were way worse than mine so I wonder if there is another way to fox that without replacing the whole reinforcing plate.

IMG_20200426_151314.jpg


received_1799040946904807.webp
 
Last edited:
I am sure it’s fixable. But if that area is that bad it’s very likely everywhere else is too. So if this is fix to get another year or two out of then seems doable.
 
Oh man, that's sum rust..Make sure you look the hole frame over to make sure it's not too bad elsewhere. The rear inner C's are prolly toast too ?
It's doable, but is the rest up to it ? Any more pics ?? Can u weld ?
 
It's the only places on the frame that are bad. The rest is in good shape.


I can weld.
 
Yes i did , it's super solid everywhere else.

I'm planning on putting it on the road asap , wich means that I need to pass a safety check and do a proper fix for the frame.
 
You likely need to find a frame shop with a master welder, and get their opinion. I've seen that level of frame rust repaired successfully, but you need to know what you're doing or hire someone who does.

My frame looked like that and I replaced it. While it was in the shop, a guy with a similar frame was out on a logging road and snapped his in half...
They fixed it up pretty nicely, but there was a lot of fabrication and boxing done on the original frame.

Unfortunately the frame rusts from the inside out, and i can see just looking into the holes that you are showing that the frame is pretty compromised onside. Not unfixable, but a pretty big job.
 
Years ago I had a saveable but still rusty rover frame. We had the advantage of the the frame being out of the truck and could put it in a rotisserie:

1588084575900.webp


1588084610096.webp
 
Before you start know the local rules:
-weld in like a puzzle piece (a lot of work but very nice when finished) or weld on (fast) Both ways are extremely durable and will last for years.
-thickness (original 3 to 4 mm)
-is a support strut allowed to weld or replace as a whole piece?

2_c0a1af0074eabe3470eea87269f8e493_t.jpg


2_8832df909aecaadb960f392242a0d202_t.jpg


It is easier to remove the complete support to acces properly and then replace the rivets with bolts:

2_1cd671eb89e7844018fbc998e11160f2.jpg
 
Back
Top Bottom