Replace wheel stud

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Just did it today. I advise removing the hub so you can support the flange as you wale on it to remove the old stud. You can put the new stud in with a press, proper support with a drift and a hammer or you can use an M12x1.5 nut, and a washer and draw it in with a wrench. Do you need a part number?
 
Guy who did this for us in Nicaragua used an old bearing as a "washer" and wrenched it in with the lug nut.
 
Rotor must come off. Depending on how much of a lip there is in the e-brake drum this may require retracting the e-brake pads. If you do so try to remember how many notches you back off.. and match it when reassembling.

Second what @baldilocks says about supporting hub being better for the bearing.. though it's a LOT less work if you just do it with a hammer.. it's just not done right.
 
I've replaced all the wheel studs on a 3 axle semi without removing the hubs to press the studs in or out. If you can knock the old one out and have room to get the new one back in I say go for it. I will also say if you go that route to torque the wheel nuts, go for a very short drive, retorque the wheel nuts, and then torque them again in 50 miles, and again in 100 miles
 
Take the rotor off, pound it it out with a hammer, use punch and WD-40 first if necessary if it is stubborn. I found that putting the new one on is easy enough, just start the stud, add a few washers on the other side, then tighten a lug nut on the end until it pulls the lug stud tight enough.
 
If you had one fail I'd replace all of them. But that is just me.
Agreed! At least change the ones on either side of it
 
Back
Top Bottom