Removing Warden Pitman Arm

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Cruiserdrew

On the way there
Joined
Mar 15, 2003
Threads
219
Messages
15,839
Location
Sacramento, CA
I have a Saginaw conversion done by Warden's about 5-6 years ago. They used a huge 1/2 inch plate pittman arm that is too wide for the widest Pittman arm puller I have. THe Jaws are 2.5 inches apart and the pitman arm is 3.5 inches. Any ideas for removing this beast? I have looked for a wider puller, but it doesn't seem to exist.

Thanks for any tips or advice.
 
Andrew,

Have you tried a rosebud tip and a hammer?

Charles


I didn't know if the hammer would damage the internals of the box. I am reusing the box in my rebuild but I have a "normal" pitman arm for it.

Regarding cutting to size-All I have is an angle grinder which would take forever with this chunk of steel.

Keep the ideas coming.
 
Try an impact hammer with a blunt tip. Crank the air to the highest setting the gun will handle. Place the tip against the back of the arm right at the splines, have a BFH in the other hand or have a helper with same. Start pounding while you run the impact around the back of the arm. It takes mine off easily every time!
 
A ton of liquid wrench also? I don't remember what I used but it took me two or three days to get my stock pitman arm off. A lot of heat, a lot of solvent, a lot of swearing. I went to sears to buy a gear puller because I broke the one I rented from the Auto parts store.
 
I would just run the Warden arm. Why screw with it if it isn't broken?


I can't run the Warden's arm as I am switch ing to 1 ton drag link ends and the taper is for FJ40 ends.


I did get it off today. I had to dismount the box, cut the plate down with and angle grinder and use the big pittman arm puller. PIA. I put the new arm on but checked first that it would fit the pullers I have!

Anyone who needs this Pittman arm can have it-just realize it's been cut about 1/2 inch on each side, but there is still plenty of meat. Sagimaw on one end and FJ40 tie rod taper on the other end. Just let me know.
 
Anyone who needs this Pittman arm can have it-just realize it's been cut about 1/2 inch on each side, but there is still plenty of meat. Sagimaw on one end and FJ40 tie rod taper on the other end. Just let me know.


Andy, as long as it's 7 inches or better from center to center, I am definitely interested.;)
 
Andy, as long as it's 7 inches or better from center to center, I am definitely interested.;)

Great-Glad it can go to a good home. Look for it in the next couple of weeks. I'll get the shipping address from your website.
 
Back
Top Bottom