Remove front exhaust pipe to pull the engine?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 18, 2015
Threads
3
Messages
8
Location
Netherlands
I'm at step 26 of the FSM engine removal procedure, I need to disconnect the front exhaust pipe from the catalytic converter. Until now I have not stripped or broken a single bolt, but the bolts at the catalytic converter seem seriously rusted so I'd rather leave them alone.

Can the engine and transmission be pulled if I just remove the four bolts of the front exhaust pipe and disconnect the No. 1 support bracket? Or isn't there enough room to pull engine and transmission if I leave the front exhaust in place?
 
Unbolt the headers from the block then unbolt the
From the two down pipes. This is what I did and it worked fine. Photos in my build thread if you want a visual reference
 
Thanks!
@SmokingRocks, thanks for the inspiring build thread, I'm still dizzy from looking at your dashboard.
I'm actually removing the engine including transfer case and transmission. Seems like the transfer case might be a bit tight but it should work.
Hopefully there is enough room to leave the transfer case shifter on, those 4 bolts are a pain to get to.
Looking at Engine trans removal and , it should be possible to get the whole thing out in one piece.
 
I just pulled mine the same way a few days ago, engine, transmission and xfer case. Go ahead and get the oil cooler and ac condenser out of the way, and remove the front valance, mine got mangled. Also, there are a few electrical connectors that go up over the transmission and some small hidden heater hoses under the heater valve that are not super obvious an aren't specifically mentioned in the FSM. When you put your load leveler on, it is very important that you chain the back side engine hook as close to level as you can, so that you can get the transfer case high enough. You might also want to have a comalong handy to connect to the transmission to lift it the last little bit to clear the bumper.
 
Back
Top Bottom