Rear axel Studs

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 20, 2006
Threads
13
Messages
23
Location
Brisbane Australia
Hi,

Does anyone have any tips to remove the collets from the axel studs. These are a real pain to get out. There must be an easier way for sure than hitting the centre of the axel to pop them out?

Thanks in advance. I searched but couldn't find anything. maybe u guys call them something else?

thanks
 
Collets = conical washers I'm guessing. Use a brass drift and a medium hammer, try to drive the stud straight into the hub. You don't have to kill it, but don't be shy. Loosen the nuts, but leave them on the stud to keep the conical washers from flying off. You want to be contacting the end of the stud though, not the nut.

-Spike
 
Hit the axle housing opposite each stud with a 3 lbs BRASS hammer. Make sure you have the nuts on loosely so the washers don't go flying.
 
I use a blunt bit in an air hammer and hit the axle face, works great.

Never tried that method, probably works faster than mine. Sounds like the same principle. Tried using a brass drift and hammer to the side of the hub, but I personally don't like it, seems to put an awful lot of stress on the bearings (all the force transmits through one or two rollers, vs. hitting the face of the hub which disburses the force across all of the rollers), plus it took more blows, effort, and time. The force imparted to the bearings may or may not be an issue, but hitting the studs worked quickly for me.

-Spike
 
Collets = conical washers I'm guessing. Use a brass drift and a medium hammer, try to drive the stud straight into the hub. You don't have to kill it, but don't be shy. Loosen the nuts, but leave them on the stud to keep the conical washers from flying off. You want to be contacting the end of the stud though, not the nut.

-Spike
By far I have found this method to be the best.
:beer:
 
I was dead set on the brass hammer method until I stumbled across someone recommending the tiny screwdriver method over in 40land.. tried it the other night and wow. If you can tap a tiny screwdriver into the slot in the cone washer with a small hammer it will not only pull out of the tapered hole, but it will also grow in ID and slide off the stud almost instantly and effortlessly. Slot doesn't even have to be towards the "outside" just tap your little screwdriver in there straight on (parallel with the stud even works) and you'll be amazed how easy they slide off. hth..
 
Back
Top Bottom