Real time Advice ( Water Pump replacement )

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 4, 2003
Threads
422
Messages
23,683
Location
Panamá
Website
www.4x4panama.com
Hello there I'm in the middle of the described job in the title and feeling that the water pump matching surface it's not as smooth as I would like.

Would be the OEM gasket enough or its advisable like coat of FIPG? View attachment 1472653

comments are appreciated ..

thanks

David
 
Get a scraper razor blade and clean those surfaces up well being careful not to gouge the aluminum surface on the head (if the head is even aluminum, looks a little red to me on the left).. then follow with a light stainless wire brush.

After that I don't think you need, and I wouldn't use FIPG, personally.
 
Thanks for replies.. Ende with a razor blade and more razor blade plus wire brush plus sand paper and just OEM gasket.. When I was almost done discover an small leak on my rad ( most likely an involuntary hit from my fight with he timing gear) Big bloomer to say the least.. So that water pump test will need to wait a couple of extra days..
 
Back
Top Bottom