Rattle can color....

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 8, 2013
Threads
282
Messages
1,476
Location
North GA
image.webp
I've decided to paint my LX450 cladding. I've done a lot of searching and I think I'm going to rattle bedline with the color shown. Blacked out front and rear bumpers with this desert tan bedliner for the rest.

Pics, ideas, or suggestions for or otherwise?

Original white LX with champagne cladding.
 
6- cans of Krylon Ultra flat khaki. no streakiness - just dead flat - prep was sanding crappy old paint with d/a and some 220grit. $42 later.....



image.webp


image.webp


image.webp
 
Last edited:
the plan is to let the california sun take its toll for a season or two which should darken it slightly.........then i will shoot it with some SEM flat U V clearcoat. second one in from leftside. For prep you could easily just get tthe clearcoat/ shine off the oem cruiser paint with hand sanding 220grit and a small sanding block. 6" d/a sander just made it faster.

image.webp



and with leftovers i did some cool t-shirts for work....camo rocks!

image.webp
 
Last edited:
I used that rustoleum bed liner for my front bumper. One year later it looks like crap. Chips everywhere. I wouldn't use it again, personally.

I used flat black Rustoleum Professional for the bottom half of my truck after sanding the clear off. I used a orbital sander with 220 grit, then wet sanded wth 400 grit. I used 3 or 4 coats plus two coats of primer. Very happy with it. I think I'll be using the khaki camoflauge spray in the spring for the whole truck a la @1shot1kill.


Sent from my iPhone
 
image.webp
Did one side only.....I think it's too light. Cladding is kinda starting to get on my nerves now :mad:

Almost want to just rip it off :cool:

That or I'm going with some sort of textured black.

We'll call her angry panda 2 (my '91 was the original).
 
A for effort.

Fwiw, I sprayed the bottom of my four doors without prepping than looked at all four and decided on black until I go all one color. I think it turned out ok.

Cladding sucks.
 
the ultra flat doesnt need much build.......i had sanded down to grey oem primer and did a very thin 1st coat of the ultra flat khaki thinking i would go over it again.........and it turned out i only needed to touchup a few thin areas and called it good enough.
 
no way you painted that whole truck with 6 spray cans?

Was thinking the same. But then I thought about how much I used for my bottom half of my truck. 2 1/3 of the big cans of Rusoleum Professional. So about 3 cans.
 
IMG_5328.webp
 
The above pic looks good. I'm torn now. To pull or not to pull the cladding!? I've read all the pros and cons of doing it.....and I like the look of both. All white with monstaline white where cladding used to be would look tough though; or white with the cladding painted black rustoleum liner??

Looks like these are my options now.
 
Think I might go with this.....ultra flat black on top of the bedliner; I think it looks pretty good. I called today and it's 350 for Line X after I do all the prep work.

Gonna roll with this I think and keep the cladding. For now.
image.webp
 
View attachment 1175975 Did one side only.....I think it's too light. Cladding is kinda starting to get on my nerves now :mad:

Almost want to just rip it off :cool:

That or I'm going with some sort of textured black.

We'll call her angry panda 2 (my '91 was the original).
View attachment 1175975 Did one side only.....I think it's too light. Cladding is kinda starting to get on my nerves now :mad:

Almost want to just rip it off :cool:

That or I'm going with some sort of textured black.

We'll call her angry panda 2 (my '91 was the original).

I'll be honest. I like it a lot. But doesn't go well with the black wheels.
 
I finished it up this evening, but now it's dark so I'll have better pics tomorrow.

I like my FJ steelies :flipoff2:

Here's a pic of what I'm going for........

image.webp
 
So I'm actually pretty happy with the final result. Lots of prep is key! And don't rush.

Ill probably be selling my side mirrors and buying some black ones as well as tint to finish out the black accents.

image.webp
 
Back
Top Bottom